Problem using FEC on a860T
well, actually the patch worked only partially...
the driver compiles, and registers properly, but doesn't seem to handle RPC correctly.
I have the following message :
when both fec and normal CPM ENET are compiled,
RPC: sendmsg returned error 101
portmap: RPC call returned error 101
Root-NFS: Unable to get mountd port number from server, using default
then a second atempt on the default port, with the same error.
I have captured no packets on any of the interfaces.
when I compile only with fec ( no CPM ENET )
it blocks at
Looking up port of RPC 100003/2 on 172.16.0.1
I still can't capture any packets,
the feth enable led isn't lit,
and the collision and Tx leds of the board FOR THE CPM are blinking continuously...
after a couple of seconds, the kernel starts scrolling
eth0: tx queue full!.
did I do something wrong ???
thx
Jeremy
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 9 lines
well, actually the patch worked only partially...
...
after a couple of seconds, the kernel starts scrolling
eth0: tx queue full!.
Could you try the unpatched kernel, with a full duplex ethernet cable plugged into the FEC RJ45 connector when you boot the board ?
Laurent Pinchart
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/