Skip to contentSkip to conversation

mysterious power off problem 2.4.10-2.4.14 on laptop

DISCUSSION Thomas Winischhofer 1 participant 1 message Nov 12, 2001

lore
Share & tools
lore
#0 lore raw

Linda,

it could be a bad BIOS.

I don't know if this helps, but anyway:

I had a similar problem, but in ma case the machine just went to suspend mode - annoying, but somewhat easier to track. Just like in your case, nothing worked; switching off APM in BIOS, disabling APM in kernel, etc. no matter what I did (typing, using the mouse), the machine suspended.

Well:

Question 1: Are you running Windows on that machine, too? If no, you have a different problem; as said, most probably caused by a bad BIOS. That it worked under a previous 2.4.x kernel doesn't mean a lot; apm could have interpreted bad (malformed) apm messages in a different way (just a guess).

Question 2: If yes: Did you ever happen to try to boot (ie cold boot = switch ON) the machine with AC power chord connected after a Windows session?

In my case, it was a bug in the BIOS. This piece of sh** - right after a Windows session - reported a battery charging status of _more_ than 100%, leading into miscomprehending APM messages from the BIOS - leading into APM confusion. Strange enough, this _only_ happened when _switching on_ the machine on battery. It never happens when booting with AC connected.

Even more strange, in my case it is sufficient to cold boot the machine _once_ after running Windows on AC to avoid the effect in the future (however, until running windows again).

Good luck,

Thomas

Signature · 3 lines
Thomas Winischhofer
Vienna/Austria                  Check it out:         
mailto:[email protected]              *** http://www.webit.com/tw