Skip to contentSkip to conversation

RFC: ethernet links should remember routes the same as addresses

DISCUSSION Christopher Friesen 1 participant 1 message Nov 29, 2001

lore
Share & tools
lore
#0 lore raw

I just wanted to get some opinions on this for possible inclusion in 2.5. Alexey, if you have any comments...

The scenario is as follows:

Suppose I have a fancy routing setup, dynamically configured by different binaries, scripts, etc, complete with multiple addresses per link, additional routing rules and tables specified using iproute2, etc.

An ethernet driver hangs. Could be a software bug, an intermittent hardware issue, whatever. It can be fixed up by setting the link down and up.

Currently, if I run "ip link set dev ethX down", all routes associated with that IP address in the additional routing tables are lost. This is somewhat understandable, as the addresses are not actually available anymore. However, the addresses are still visible associated with the link. Then I run "ip link set dev ethX up". The route in the main routing table comes back, but none of the other routes do. Somehow, all of those additional routes must be re-added.

Wouldn't it be nice if we could keep track of these additional routes? Then you could simply 'down' and 'up' the link and everything would be back the way it was before.

Does this sound like a good idea? How hard would this be to implement (not knowing what the current code looks like, I don't know how this would be done)?

Chris Friesen

Signature · 4 lines
Chris Friesen                    | MailStop: 043/33/F10  
Nortel Networks                  | work: (613) 765-0557
3500 Carling Avenue              | fax:  (613) 765-2986
Nepean, ON K2H 8E9 Canada        | email: [email protected]