Skip to contentSkip to conversation

traditional bug: only one of two serial ports found on HP Vectra XM

DISCUSSION Ulrich Windl 3 participants 3 messages Apr 17, 2002

lore
Share & tools
lore
#0 lore raw

Hello,

historically I believed Linux very much. When it said my HP Vecra XM only has one serial port I was surprised, but believed it. That was some years ago. 2.4.18 still says that there is one serial port:

ttyS00 at 0x3f8 (irq=4) as a 16550A

However recently I had to work on the backside of the PC and found two(!) serial ports labelled "Serial A" and "Serial B". So shouldn't both ports be detected?

Regards,
Ulrich Windl
(the one who is NOT subscribed in this honourable list)

#1 lore raw
Quoted 9 lines · Ulrich Windl

historically I believed Linux very much. When it said my HP Vecra XM only has one serial port I was surprised, but believed it. That was some years ago. 2.4.18 still says that there is one serial port:

ttyS00 at 0x3f8 (irq=4) as a 16550A

However recently I had to work on the backside of the PC and found two(!) serial ports labelled "Serial A" and "Serial B". So shouldn't both ports be detected?

How about opening the case and checking whether those ports actually connected to motherboard? Checking BIOS config?
Without waiting for another 'some years' :-)

Seriously, do you have any reason to think second port is really exists beside physical connector?
--
vda

#2 lore raw
In reply to Ulrich Windl
Quoted 11 lines · Denis Vlasenko
Quoted 9 lines · Ulrich Windl

historically I believed Linux very much. When it said my HP Vecra XM only has one serial port I was surprised, but believed it. That was some years ago. 2.4.18 still says that there is one serial port:

ttyS00 at 0x3f8 (irq=4) as a 16550A

However recently I had to work on the backside of the PC and found two(!) serial ports labelled "Serial A" and "Serial B". So shouldn't both ports be detected?

Quoted 6 lines

How about opening the case and checking whether those ports actually connected to motherboard? Checking BIOS config?
Without waiting for another 'some years' :-)

Seriously, do you have any reason to think second port is really exists beside physical connector?

If it exists, check if "lspnp" on a PNPBIOS enabled kernel would find your second port. There have been patches to find BIOS configured serial ports even if not at standard places.