2.5.18 and HPT366
2.5.18 hangs at partition check. A workaround is to comment hpt366.c:868 config_chipset_for_pio(drive) in the function config_chipset_for_dma().
In this case the partition check looks to be done twice :
ATA: Triones Technologies, Inc. HPT366 / HPT370: controller, PCI slot 00:13.0
PCI: Found IRQ 11 for device 00:13.0
PCI: Sharing IRQ 11 with 00:13.1
ATA: chipset rev.: 1
ATA: non-legacy mode: IRQ probe delayed
ide2: BM-DMA at 0xd400-0xd407, BIOS settings: hde:DMA, hdf:pio
ATA: Triones Technologies, Inc. HPT366 / HPT370 (#2): controller, PCI slot 00:13.1
PCI: Found IRQ 11 for device 00:13.1
PCI: Sharing IRQ 11 with 00:13.0
ATA: chipset rev.: 1
ATA: non-legacy mode: IRQ probe delayed
ide3: BM-DMA at 0xe000-0xe007, BIOS settings: hdg:DMA, hdh:pio
hda: SAMSUNG DVD-ROM SD-616F, ATAPI CD/DVD-ROM drive
hde: ST310212A, ATA DISK drive
hdg: SAMSUNG SV0322A, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide2 at 0xcc00-0xcc07,0xd002 on irq 11
ide3 at 0xd800-0xd807,0xdc02 on irq 11
hde: 20005650 sectors w/512KiB Cache, CHS=19846/16/63, UDMA(66)
Partition check:
/dev/ide/host2/bus0/target0/lun0: [PTBL] [1245/255/63] p1 p2 p3 p4
hdg: 6250608 sectors w/478KiB Cache, CHS=11024/9/63, UDMA(33) /dev/ide/host3/bus0/target0/lun0: p1 /dev/ide/host2/bus0/target0/lun0: p1 p2 p3 p4 /dev/ide/host3/bus0/target0/lun0: p1
Pierre
Signature · 3 lines
------------------------------------------------ Pierre Rousselet <[email protected]> ------------------------------------------------