LASAT board mtd support
Please find attached a patch to add mtd support for the Lasat platforms. Patch applies to the 2.4 CVS branch.
/Brian
mtd/maps/Config.in +1 -0
@@ -57,6 +57,7 @@ int ' Bus width in octets' CONFIG_MTD_CSTM_MIPS_IXX_BUSWIDTH 2 fi dep_tristate ' Momenco Ocelot boot flash device' CONFIG_MTD_OCELOT $CONFIG_MOMENCO_OCELOT + dep_tristate ' LASAT flash device' CONFIG_MTD_LASAT $CONFIG_MTD_CFI $CONFIG_LASAT fi if [ "$CONFIG_SUPERH" = "y" ]; then
mtd/maps/Makefile +1 -0
@@ -38,6 +38,7 @@ obj-$(CONFIG_MTD_PCI) += pci.o obj-$(CONFIG_MTD_PB1000) += pb1xxx-flash.o obj-$(CONFIG_MTD_PB1500) += pb1xxx-flash.o +obj-$(CONFIG_MTD_LASAT) += lasat.o obj-$(CONFIG_MTD_AUTCPU12) += autcpu12-nvram.o include $(TOPDIR)/Rules.make
mtd/maps/lasat.c new file +136 -0
136 lines not on this page · raw message