serial port problem(?)
Hello.
Quoted 1 line · Dmitriy A. Kuvshinov
I use dosemu-1.1.4 and want use program for run stepping motor on
/dev/ttySn... This programm work on oldcomputers(p100, p150)
Under dosemu?
Quoted 1 line
and dont work in for example Gygabyte Intel Pentium 2000G...
If it doesn't work even under a pure DOS (ie not linux/dosemu), then it is out of question also for dosemu.
Quoted 2 lines
in boot.log my program write
"error clkin set"
The program is attempting to alter the frequency divider of the Square Wave gen on an RTC chip. This is not supported by dosemu and rarely used (so most likely the problem is elsewhere, esp. if it used to work under dosemu on another machines).
Quoted 1 line
how i can fix this problem?
Produce the -D9+hrs log on the system when your program is OK and on the system where it doesn't work. Open the bug-report on SF page and attach that logs to it. It might be possible to identify the differences.
greetings!!
Quoted 1 line
Under dosemu?
no, this program work in windows 98 on p160, and dont work in win98 on p4 2000Ghz(also on win2k)
Quoted 3 lines
If it doesn't work even under a pure DOS (ie not linux/dosemu), then it is out of question also for dosemu.
yes...
Quoted 7 lines
The program is attempting to alter the frequency divider of the Square Wave gen on an RTC chip. This is not supported by dosemu and rarely used (so most likely the problem is elsewhere, esp. if it used to work under dosemu on another machines).
hmm... :((
Quoted 6 lines
Produce the -D9+hrs log on the system when your program is OK and on the system where it doesn't work. Open the bug-report on SF page and attach that logs to it. It might be possible to identify the differences.
:((
thanks for your answer!!
Dima