How to install two linux OSes on the same PC
Hi All,
I want to do two different linux installations rh 7.2 and rh
8.0 on the same pc with single hard disk. I installed the rh 7.2 in partitions say /dev/hda5 ( /) , /dev/hda6 (/home) , /dev/hda7 ( /usr) ,/dev/hda8 ( /tmp),... /dev/hda11 etc.
But how can I install the rh 8.0 in partitions say /dev/hda12
( as "/" ) ... etc ?? Since the installer won't allow as there already exists a "/" partition for the rh 7.2 and tries to override it with the root partition of rh 8.0. So I tried giving a different lable to the root partition of rh 8.0 say /root1 and other partitions as /root1/usr, /root1/home, /root1/tmp etc. But here also the installer is looking for the partition named "/" and without that the installation is not happening.
Please give your suggestions on how to resolve this problem.
At present my partition table with single installation (rh 7.2) is,
[root@creddy-pc root]# fdisk -l
Disk /dev/hda: 255 heads, 63 sectors, 2434 cylinders Units = cylinders of 16065 * 512 bytes
Device Boot Start End Blocks Id System /dev/hda1 * 1 261 2096451 6 FAT16 /dev/hda2 262 2434 17454622+ 5 Extended /dev/hda5 262 522 2096451 6 FAT16 /dev/hda6 523 653 1052226 83 Linux /dev/hda7 654 1175 4192933+ 83 Linux /dev/hda8 1176 1371 1574338+ 83 Linux /dev/hda9 1372 1436 522081 82 Linux swap /dev/hda10 1437 1501 522081 83 Linux /dev/hda11 1502 1566 522081 83 Linux
[root@creddy-pc root]#
TIA,
- Narsimha Reddy CH
Quoted 2 lines · Narsimha Reddy CHALLA
Please give your suggestions on how to resolve this problem.
I think this should work: After the first install change the volume labels on the existing partitions (with e2label), changing /etc/fstab at the same time. Then, you can use the labels the installer wants on the second install.
Signature · 2 lines
David Kleikamp IBM Linux Technology Center
Thanks a lot for your help. It really worked with disk driud. It cleverly managed the name conflicts of lables i.e. for first installation the root is "/" and for the second installation the root lable is "/1". After editing /etc/lilo.conf of first one and /sbin/lilo, I can boot both of them using.
Regards,
- Narsimha
Quoted 10 lines · Dave Kleikamp
Quoted 3 lines · Narsimha Reddy CHALLA
Please give your suggestions on how to resolve this problem.
I think this should work: After the first install change the volume labels on the existing partitions (with e2label), changing
/etc/fstabat the same time. Then, you can use the labels the installer wants on the second install.
Signature · 6 lines
Narsimha Reddy CH Storage Area Networking, HCL Technologies Contact +91-044 2372 8366 ext 1128 http://san.hcltech.com http://www.hcltech.com