AMD 29LV640D
Folks,
Has anyone used the mtd device with the AMD LV640D chips? They are 64Mbit (4Mx16) chips and are CFI-compatible.
I have a layout where 4 of these chips have been arranged over a bus width of 64bits.
I have tried the following..
MTD RAM/ROM Config section:
16bit-buswidth
4 chip interleaving
MAP section:
Buswidth in octets = 2 (Tried 8, but got "unsupported")
Using the above, all the modules (physmapcfi_probe map_rom chipreg gen_probe cfi_cmdset_0002 mtdchar mtdcore, in reverse order) get inserted, but I get a complaint of:
CFI: Found no Physically mapped flash device at location zero Can't locate module jedec_probe
So, on a whim, I inserted the following in reverse order - physmap jedec_probe cfi_probe map_rom chipreg gen_probe cfi_cmdset_0002 mtdchar mtdcore.
Again, everything gets inserted fine, but
I get "CFI: Found no Physically mapped flash device at location zero", and "JEDEC: Found no Physically mapped flash device at location zero".
*BUT*, now I am able to read from /dev/mtd0 anywhere in the flash address space. While trying to write, I get a "dd: cannot open /dev/mtd0: permission denied", even though I am root, and the permissions are fine.
Any ideas as to what might be going on?
Thanks a bunch,
-vijoy