WARNING: unexpected IO-APIC
dmesg said to send this mail :)
----------------------------------------------------------------------------------------------------------------------------------------
Linux version 2.4.19-16mdk ([email protected]) (gcc version 3.2 (Mandrake Linux 9.0 3.2-1mdk)) #1 Fri Sep 20 18:15:05 CEST 2002 BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000001fff0000 (usable)
BIOS-e820: 000000001fff0000 - 000000001fff3000 (ACPI NVS)
BIOS-e820: 000000001fff3000 - 0000000020000000 (ACPI data)
BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved)
BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
511MB LOWMEM available.
found SMP MP-table at 000f4c60
hm, page 000f4000 reserved twice.
hm, page 000f5000 reserved twice.
hm, page 000f0000 reserved twice.
hm, page 000f1000 reserved twice.
Advanced speculative caching feature present
On node 0 totalpages: 131056
zone(0): 4096 pages.
zone(1): 126960 pages.
zone(2): 0 pages.
Intel MultiProcessor Specification v1.4
Virtual Wire compatibility mode.
OEM ID: OEM00000 Product ID: PROD00000000 APIC at: 0xFEE00000
Processor #0 Pentium(tm) Pro APIC version 17
I/O APIC #2 Version 17 at 0xFEC00000.
Processors: 1
Kernel command line: BOOT_IMAGE=linux ro root=2102 quiet devfs=mount hdc=ide-scsiide_setup: hdc=ide-scsi
Initializing CPU#0
Detected 1674.444 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 3342.33 BogoMIPS
Memory: 515536k/524224k available (1176k kernel code, 8300k reserved, 444k data, 136k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount-cache hash table entries: 8192 (order: 4, 65536 bytes)
Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: Before vendor init, caps: 0383fbff c1c3fbff 00000000, vendor = 2
Advanced speculative caching feature present
Disabling advanced speculative caching
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 256K (64 bytes/line)
CPU: After vendor init, caps: 0383fbf7 c1c3fbff 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After generic, caps: 0383fbf7 c1c3fbff 00000000 00000000 CPU: Common caps: 0383fbf7 c1c3fbff 00000000 00000000 CPU: AMD Athlon(tm) XP 2000+ stepping 00
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
ENABLING IO-APIC IRQs
Setting 2 in the phys_id_present_map
...changing IO-APIC physical APIC ID to 2 ... ok. init IO_APIC IRQs
IO-APIC (apicid-pin) 2-0, 2-10, 2-11, 2-20, 2-23 not connected. ..TIMER: vector=0x31 pin1=2 pin2=0
number of MP IRQ sources: 24.
number of IO-APIC #2 registers: 24.
testing the IO APIC.......................
IO APIC #2......
.... register #00: 02000000
....... : physical APIC id: 02
.... register #01: 00178003
....... : max redirection entries: 0017 ....... : PRQ implemented: 1 ....... : IO APIC version: 0003
WARNING: unexpected IO-APIC, please mail
to [email protected]
.... IRQ redirection table:
NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect:
00 000 00 1 0 0 0 0 0 0 00 01 001 01 0 0 0 0 0 1 1 39 02 001 01 0 0 0 0 0 1 1 31 03 001 01 0 0 0 0 0 1 1 41 04 001 01 0 0 0 0 0 1 1 49 05 001 01 0 0 0 0 0 1 1 51 06 001 01 0 0 0 0 0 1 1 59 07 001 01 0 0 0 0 0 1 1 61 08 001 01 0 0 0 0 0 1 1 69 09 001 01 0 0 0 0 0 1 1 71 0a 000 00 1 0 0 0 0 0 0 00 0b 000 00 1 0 0 0 0 0 0 00 0c 001 01 0 0 0 0 0 1 1 79 0d 001 01 0 0 0 0 0 1 1 81 0e 001 01 0 0 0 0 0 1 1 89 0f 001 01 0 0 0 0 0 1 1 91 10 001 01 1 1 0 1 0 1 1 99 11 001 01 1 1 0 1 0 1 1 A1 12 001 01 1 1 0 1 0 1 1 A9 13 001 01 1 1 0 1 0 1 1 B1 14 000 00 1 0 0 0 0 0 0 00 15 001 01 1 1 0 1 0 1 1 B9 16 001 01 1 1 0 1 0 1 1 C1 17 000 00 1 0 0 0 0 0 0 00
IRQ to pin mappings:
IRQ0 -> 0:2
IRQ1 -> 0:1
IRQ3 -> 0:3
IRQ4 -> 0:4
IRQ5 -> 0:5
IRQ6 -> 0:6
IRQ7 -> 0:7
IRQ8 -> 0:8
IRQ9 -> 0:9
IRQ12 -> 0:12
IRQ13 -> 0:13
IRQ14 -> 0:14
IRQ15 -> 0:15
IRQ16 -> 0:16
IRQ17 -> 0:17
IRQ18 -> 0:18
IRQ19 -> 0:19
IRQ21 -> 0:21
IRQ22 -> 0:22
.................................... done.
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 1674.4854 MHz.
..... host bus clock speed is 267.9176 MHz.
cpu: 0, clocks: 2679176, slice: 1339588 CPU0<T0:2679168,T1:1339568,D:12,S:1339588,C:2679176>
mtrr: v1.40 (20010327) Richard Gooch ([email protected])
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xf9f10, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router default [1106/3189] at 00:00.0 PCI->APIC IRQ transform: (B0,I8,P0) -> 17 PCI->APIC IRQ transform: (B0,I15,P0) -> 19 PCI->APIC IRQ transform: (B0,I16,P0) -> 21 PCI->APIC IRQ transform: (B0,I16,P1) -> 21 PCI->APIC IRQ transform: (B0,I16,P2) -> 21 PCI->APIC IRQ transform: (B0,I16,P3) -> 19 PCI->APIC IRQ transform: (B0,I17,P0) -> 22 PCI->APIC IRQ transform: (B0,I17,P2) -> 22 PCI->APIC IRQ transform: (B0,I19,P0) -> 18 PCI->APIC IRQ transform: (B0,I20,P0) -> 16 PCI->APIC IRQ transform: (B1,I0,P0) -> 16
PCI: Via IRQ fixup for 00:10.0, from 11 to 5
PCI: Via IRQ fixup for 00:10.1, from 11 to 5
PCI: Via IRQ fixup for 00:10.2, from 11 to 5
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
<snip>