What kind of Linux address must I use to set the SAR reg. of the DMA ctrl ?
Thanks a lot Matt,
now the Memory to memory transfer works but I don't see any data on the PCI side althought the status register of the DMA controller report no error. I read that I must use untranslated PCI address if the outbound translation windows are not enabled (this is my case).
So I suppose I must take the address coming from the PCI detection and the ioremap following it (those appearing in the log like "kernel :PCI:00:12.0:
Resource 1:bf000000-bf7FFFFF") and not the translated one.
I tried so but only 0XFFFFFFFF appears in the memory of the PCI device. Is it possible that the snooping or caching issue be the problem ?
Regards,
Benoit Callebaut
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/