Apollo 9000 power problem
Hello HP Hackers !
I have a work around for the POWER SUPPLY Problem.
Using schematics and analysing this very very hard thing, I found out, that the problem we all have was created by an exploded capacitor.
The thing running out of the capacitor mixed with the dust in the machine generates an resistor on the PCB board.
On the low voltage end of the power supply (near front), ther is a small SIM-like module which does the supervision of all volatage lines (plus over current protection) and which generates the reset impuls.
Now to the problem. The line coming from the current measure transformer is the neighbour line of the -12V line. Because of the electrical resistor because of the dust, etc, the negative voltage comes to the current supervision line, and therefore one supervision comperator does a wrong failure reaction !
Workaround:
- step 1 -
Try to clean the space on the PCB around this supervison module. (I soldered it out for cleaning, a resoldered it in)..
- step 2 -
This helps. But after weeks the problem returned again .... I soldered in a resistor between the +Vaux (about 12..16V) and this current measure line to compensate this negativ voltage of the -12V line.
This is no relevant impact to the over-current protection, as the resistor has a high value against the measurement output.
This worked for me.
If you need help on this, please contact me ...
Christoph
Signature · 3 lines
------------------------------------------------------- private: [email protected] company: [email protected]