Anyone using a NEC e606 and BlueZ?
Hi!
I have serious problems keeping the ppp-connection via bluetooth. The system is as follows:
mh3-patched Linux 2.4.21
IOGEAR GBU-301 (USB BC2033)
NEC e606 (3G/UMTS) Mobile
Using bluefw I get hci0 working.
Binding with rfcomm works.
I connect with rp3-config (RedHat ppp-dialer config) the connection comes up, setting routing etc. after a few moments (10-30 sec) te connection dies.
After that the bluetooth device seems stop working...
Any ideas? Any part of BlueZ kernelpatches I must have? (I think I didn't put i zero-packets) Should I post any specific dumps/logfiles?
TIA
Fredrik
Signature · 15 lines
******************** Fredrik Hallgårde [email protected] ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Bluez-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/bluez-users
Marcel Holtmann
maintainerHi Fredrik,
Quoted 6 lines
I have serious problems keeping the ppp-connection via bluetooth. The system is as follows:
mh3-patched Linux 2.4.21
IOGEAR GBU-301 (USB BC2033)
NEC e606 (3G/UMTS) Mobile
Quoted 7 lines
Using bluefw I get hci0 working.
Binding with rfcomm works.
I connect with rp3-config (RedHat ppp-dialer config) the connection comes up, setting routing etc. after a few moments (10-30 sec) te connection dies.After that the bluetooth device seems stop working...
first, give us some infos about your devices.
hciconfig -a hcitool info <nec-e606-addr> sdptool browse --tree <nec-e606-addr>
Quoted 2 lines
Any ideas? Any part of BlueZ kernelpatches I must have? (I think I didn't put i zero-packets) Should I post any specific dumps/logfiles?
Using 2.4.22-mh1 should be fine. A "hcidump -w <file>" and the pppd logs will maybe help.
Have your tried other programs like "attest" from bluez-utils/test/ directory to verify that some stuff is working.
What is your data layer? GPRS? Do have special AT commands for the PPP setting?
What happens if you use "rfcomm connect ..."? Is the RFCOMM connection also closed or did only the PPP part dies.
Regards
Marcel
-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
_______________________________________________
Bluez-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users