PQ2FADS Support

Hello,

I am working with a Motorola PQ2FADS board. I currently have a "free" teaser distribution from a vendor that works for the board. The FADS board is not the ultimate target.

I tried to use the latest ATM driver for the PQ2, but have lots of unresolves due to the vendor mods in the low level stuff.

I would like to use the eldk, but, when I pulled down the latest CVS version this morning and try to configure there is not an option for PQ2FADS.

I would rather go with the ELDK since it is has a larger tool set and support is through the community.

So, does anyone have a .config and associated support for PQ2FADS-VR ? (8275-VR 266/166/66) Suggestions?

Thanks
Kevin

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

I think this is a misunderstanding. The ELDK is a _toolkit_, not a kernel distribution. (Yes, the ELDK does contain a Linux kernel source tree, too - the current version of the ELDK contains our 2.4.4 kernel tree).

But if you're looking at specific board support, you can use _any_ kernel source tree in combination with the ELDK tools.

Best regards,

Wolfgang Denk

--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] 1 1 was a race-horse, 2 2 was 1 2. When 1 1 1 1 race, 2 2 1 1 2.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/