libata testing on new machine with ICH5 and PDC20318
I'm building a new server to go into a colo facility in about six weeks; the machine will have an Intel motherboard with an ICH5R (although I won't use the RAID features) and a Promise SATA150 TX4 (no RAID support). All six SATA ports will have Seagate 160GB Barracuda drives attached, and I plan on using software RAID-5 and LVM2 on top of the array.
I will be building the system using 2.6.0-test9, so will be using libata to drive the disks. If there's anything I can help with debugging/testing the ICH and/or Promise SATA drivers let me know... I see that recently Jeff posted a small patch for some SATA reset issues against -test9, so I'll certainly start out with that included.
Quoted 3 lines · Kevin P. Fleming
I'm building a new server to go into a colo facility in about six weeks; the machine will have an Intel motherboard with an ICH5R (although I won't use the RAID features) and a Promise SATA150 TX4 (no RAID support). All six SATA ports will have Seagate 160GB Barracuda drives attached, and I plan on using software RAID-5 and LVM2 on top of the array.
I will be building the system using 2.6.0-test9, so will be using libata to drive the disks. If there's anything I can help with debugging/testing the ICH and/or Promise SATA drivers let me know... I see that recently Jeff posted a small patch for some SATA reset issues against -test9, so I'll certainly start out with that included.
The ICH5 should be fine. You may need to twiddle BIOS setup options, some users have reported that both drivers/ide and libata fail in certain BIOS modes. "Enhanced - SATA only" is usually the preferred mode, where feasible.
You need to make sure you get the Promise SATA fixes I just pushed to Linus. Presumably they will be available in the next 2.6.0-testX BK snapshot on ftp.kernel.org, tonight or the next night.
Jeff
Quoted 1 line · Jeff Garzik
The ICH5 should be fine. You may need to twiddle BIOS setup options, some users have reported that both
drivers/ideand libata fail in certain BIOS modes. "Enhanced - SATA only" is usually the preferred mode, where feasible.
I forgot to mention I will not be booting off of any of the SATA disks, so that should cover the BIOS issues by just ignoring them.
Quoted 2 lines
You need to make sure you get the Promise SATA fixes I just pushed to Linus. Presumably they will be available in the next 2.6.0-testX BK snapshot on ftp.kernel.org, tonight or the next night.
I saw that message; I won't have the hardware until late next week, so I'll watch to see what happens with the snapshot/-testX situation by then.
I'll have about three weeks to use the machine for "whatever" before I have to start preparing it for its real purpose, so if there's any stress tests or anything I else I can run that would be useful let me know.