Skip to contentSkip to conversation

CVS, ALC655 ->Line-In to Surround not working

DISCUSSION R Chan 2 participants 2 messages Nov 16, 2003 – Nov 17, 2003

lore
Share & tools
lore

R Chan

author
#0 lore raw

Hi,

Upgraded to CVS to get ALC655 support on a KT600 motherboard and VIA8233 south bridge. ac97 codec is identified as ALC655 rev 0.

I have unmuted all the usual suspects (PCM, Master, LFE, Center Surround, except the down mix controls) and I have unmuted "Line-In As Surround" and "Mic As Center/LFE". I also use the surround51 device which
references device 1 (is this the 6-channel device?)

Unfortunately I can't get any sound out of the surround or center/LFE speakers. When I try something like

pcm.testrear {
type plug

   slave {
      pcm "hw:0,1"
      rate 48000

}
ttable.0.2 1
ttable.1.3 1
}
(I presume channels 2 and 3 are the rear speakers)

aplay -Dtestrear foo.wav

gives no sound. Any suggestions?

Thanks
Richard

-------------------------------------------------------
This SF. Net email is sponsored by: GoToMyPC
GoToMyPC is the fast, easy and secure way to access your computer from any Web browser or wireless device. Click here to Try it Free!
https://www.gotomypc.com/tr/OSDN/AW/Q4_2003/t/g22lp?Target=mm/g22lp.tmpl

#1 lore raw

At Sun, 16 Nov 2003 20:25:33 +0800,

Quoted 9 lines · R Chan

Hi,

Upgraded to CVS to get ALC655 support on a KT600 motherboard and VIA8233 south bridge. ac97 codec is identified as ALC655 rev 0.

I have unmuted all the usual suspects (PCM, Master, LFE, Center Surround, except the down mix controls) and I have unmuted "Line-In As Surround" and "Mic As Center/LFE".

try turn "on", suppose that these jacks are shared.

Quoted 3 lines

I also use the surround51
device which
references device 1 (is this the 6-channel device?)

yes.

Quoted 13 lines

Unfortunately I can't get any sound out of the surround or center/LFE speakers.
When I try something like

pcm.testrear {
    type plug
    slave {
       pcm "hw:0,1"
       rate 48000
    }
    ttable.0.2 1
    ttable.1.3 1
}
Quoted 1 line

(I presume channels 2 and 3 are the rear speakers)

you can turn on "Duplicate Front" switch instead.
then the front signal is routed to the rear speakers on hardware.

Takashi

-------------------------------------------------------
This SF. Net email is sponsored by: GoToMyPC
GoToMyPC is the fast, easy and secure way to access your computer from any Web browser or wireless device. Click here to Try it Free!
https://www.gotomypc.com/tr/OSDN/AW/Q4_2003/t/g22lp?Target=mm/g22lp.tmpl