Skip to contentSkip to conversation

Kernel hang with Jaz

DISCUSSION Eric Towers 1 participant 1 message Dec 18, 2003

lore
Share & tools
lore
#0 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

I have (re-)discovered a problem with vectoring from LILO to the Linux kernel (2.4.x). When there is no cartridge in my Jaz drive, LILO will load and uncompress the kernel, then hang. Cartridge in Jaz: LILO successfully vectors to the kernel.

This does not appear to be a well documented problem. I found references on a Linux PPC page. Then (finally) section 6.6 of
http://packetstormsecurity.nl/linux/admin/Mini-HOWTOs-FAQs/Jaz-Drive
(The Mini-HOWTOs appear to have generally vanished from the obvious sources.) This reference states <quote>
6.6. What happens if there is no disk inserted when I boot ?

The kernel will try to read the partition table, but the operation will (eventually) time out.

When you change disks, it is a good idea always to use fsck to check the partition structure on the new disk.

The BIOS on some SCSI host adapters will attempt to read the partition table on your disk during the system boot. If you cannot disable this check, you may be forced always to boot with a disk in the drive. </quote>

I have not observed a timeout. I have left this machine idle for a week. (I was going on vacation, so this wasn't a significant burden.)

Turning the Jaz drive off to ensure that I can't use it under Linux is also a workaround (of no utility).

The reference describes a workaround that will accelerate the death of the inserted cartridge. How can I help fix this (not a programmer)? or help champion fixing it?
- --
~ -- Eric Towers ! [email protected]
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQE/4RwnEJrYj/1UkJARAuPDAJ0XAbu6LsopNGUBCw+ZpAUAR4yIBACggZgv C5U1RkFj3zQippngOjtu63A=
=/pr7
-----END PGP SIGNATURE-----