ACPI and CardBus

Hello,

Here is my problem :
- with acpi enabled, the system hangs after loading the module yenta_socket (my keyboard is locked)
- when acpi is disabled, linux boot normaly (but I think it freeze approximately 5-10 min later...)
- when pcmcia is disabled, it functions perfectly with (or without) acpi.

I use linux 2.6.1 (from kernel.org). I have patched the DSDT table, but it changes nothing for this problem (but it resolves an other problem ;-) ). It was the same thing with the 2.4.xx kernels...

--------------------

lspci -v returns that (for cardbus) :

00:0c.0 CardBus bridge: ENE Technology Inc CB1410 Cardbus Controller

       Subsystem: FIRST INTERNATIONAL Computer Inc: Unknown device 2750
       Flags: bus master, medium devsel, latency 64, IRQ 10
       Memory at e3fff000 (32-bit, non-prefetchable) [size=4K]
       Bus: primary=00, secondary=02, subordinate=05, sec-latency=176
       I/O window 0: 00000000-00000003
       I/O window 1: 00000000-00000003
       16-bit legacy interface ports at 0001

---------------

When I boot with pcmcia, yenta appears in irq 10
cat /proc/interrupts :

CPU0

 0:    1201548          XT-PIC  timer
 1:       2591          XT-PIC  i8042
 2:          0          XT-PIC  cascade
 8:          4          XT-PIC  rtc
 9:          1          XT-PIC  acpi
10:      57977          XT-PIC  uhci_hcd, uhci_hcd, eth0
11:      71814          XT-PIC  ehci_hcd, uhci_hcd, VIA8233, nvidia
12:         41          XT-PIC  i8042
14:       7637          XT-PIC  ide0
15:         26          XT-PIC  ide1
NMI:          0
ERR:          0

------------------------

What can y do ??
Thank you.

PS : sorry for my english.....

-------------------------------------------------------
This SF.net email is sponsored by: Perforce Software. Perforce is the Fast Software Configuration Management System offering advanced branching capabilities and atomic changes on 50+ platforms. Free Eval! http://www.perforce.com/perforce/loadprog.html