Add a parameter to set sd driver's probe mode.
PATCH 1/1 Add a parameter to set sd driver's probe mode.
Asynchronous probe leads to the change of disk name, so it is hard to trace disk by its name for monitoring system.
Signed-off-by longguang.yue <[email protected]>
--- drivers/scsi/sd.c | 8 ++++++++ 1 file changed, 8 insertions(+)
drivers/scsi/sd.c +8 -0
@@ -99,6 +99,11 @@ MODULE_ALIAS_SCSI_DEVICE(TYPE_ZBC);#define SD_MINORS 16 +static unsigned int async =PROBE_PREFER_ASYNCHRONOUS ; +module_param (async, uint,0644 ); +MODULE_PARM_DESC (async, +"probe scsi disk asynchronously or not. Default is 1 asynchronous." ); +static void sd_config_discard (struct scsi_disk *,unsigned int );static void sd_config_write_same (struct scsi_disk *);static int sd_revalidate_disk (struct gendisk *);
@@ -3839,6 +3844,9 @@ static int __init init_sd(void)SCSI_LOG_HLQUEUE (3 ,printk ("init_sd: sd driver entry point\n" )); +if (async !=PROBE_PREFER_ASYNCHRONOUS ) + sd_template.gendrv.probe_type =PROBE_FORCE_SYNCHRONOUS ; +for (i =0 ; i <SD_MAJORS ; i++) {if (__register_blkdev (sd_major (i),"sd" , sd_default_probe))continue ;
Signature · 1 line
2.34.1
Quoted 2 lines · longguang.yue
Asynchronous probe leads to the change of disk name, so it is hard to trace disk by its name for monitoring system.
This won't work: just not doing async sd attach doesn't fix all the other causes of asynchronicity that cause sd names to change. You need to look at addressing disks by one of the permanent /dev/disk/by-* device files.
James