Introduction: I am new
Hello,
Is there a FAQ for this mailing list?
If not, here are a couple right off the bat:
1) Is it in the plans to support a "-hosts" option as found under solaris's automountd? (or for that matter, did I just miss it and it should be obvious?)
2) Is this list for developers, or for users?
3) (something's glimmering inside my brain, but not enough to formulate a third question...)
--jason
Signature · 10 lines
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Jason Brooks ~ (503) 641-3440 x1861
Direct ~ (503) 924-1861
Email to: [email protected]
Twiki: http://twiki.wrs.com/do/view/Main/JasonBrooks
Senior Systems Administration Analyst
Wind River Systems
8905 SW Nimbus ~ Suite 255
Beaverton, Or 97008Ian Kent
maintainerQuoted 8 lines · Jason Brooks
Hello,
Is there a FAQ for this mailing list?
If not, here are a couple right off the bat:
1) Is it in the plans to support a "-hosts" option as found under solaris's automountd? (or for that matter, did I just miss it and it should be obvious?)
This function is done by using a program mount in 4.0.0 and above. It does not do late mounting so all exports from a given host are mounted when accessed. See auto.net in the distribution.
Quoted 2 lines
2) Is this list for developers, or for users?
Both.
Quoted 2 lines
3) (something's glimmering inside my brain, but not enough to formulate a third question...)
Don't know the answer to that one.
Ian
Thank you for your reply.
When you say:
Quoted 1 line
This function is done by using a program mount in 4.0.0 and above.
Do you mean when using a later version of the mount/umount program? Or Autofs version 4.x.x? Or perhaps the kernel autofs4.o module? <insert other possibilities here>
Quoted 1 line
It does not do late mounting so all exports from a given host are mounted when accessed. See auto.net in the distribution.
Aha! It's a "program" map type! I thought that might be required. Thanks.
Quoted 4 lines
Quoted 2 lines
3) (something's glimmering inside my brain, but not enough to formulate a third question...)
Don't know the answer to that one.
As long as it isn't something akin to "a b-b rolling around in a boxcar". :)
Thanks again!
--jason
Ian Kent
maintainerQuoted 8 lines · Jason Brooks
Thank you for your reply.
When you say:
Quoted 1 line
This function is done by using a program mount in 4.0.0 and above.
Do you mean when using a later version of the mount/umount program? Or Autofs version 4.x.x? Or perhaps the kernel autofs4.o module? <insert other possibilities here>
autofs. An updated autofs4 module is not needed to do this.
Ian