Promise TX2-plus and kernel 2.6
Hi!
Does anybody know what level of support that is planned for the Promise TX2 Plus SATA disk controller in the 2.6 kernel? My understanding is that the PATA channels will not work under 2.6, while it works fine under 2.4. This does have some influence on deciding whether to upgrade to 2.6 :-(
best regards
Keld
Quoted 5 lines · Keld Jørn Simonsen
Does anybody know what level of support that is planned for the Promise TX2 Plus SATA disk controller in the 2.6 kernel? My understanding is that the PATA channels will not work under 2.6, while it works fine under 2.4. This does have some influence on deciding whether to upgrade to 2.6 :-(
No Linux kernel, 2.4 or 2.6, supports the PATA channels currently. Only the SATA channels are supported.
Jeff
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Quoted 10 lines · Jeff Garzik
Quoted 5 lines · Keld Jørn Simonsen
Does anybody know what level of support that is planned for the Promise TX2 Plus SATA disk controller in the 2.6 kernel? My understanding is that the PATA channels will not work under 2.6, while it works fine under 2.4. This does have some influence on deciding whether to upgrade to 2.6 :-(
No Linux kernel, 2.4 or 2.6, supports the PATA channels currently. Only the SATA channels are supported.
I am running linux kernel 2.4.22-26mdk and it supports PATA right out of the box, on a Promise TX2-plus controller. I have one disk on the PATA port (and one disk on one of the SATA ports). I would probably like to run kernel 2.6, mostly because I think of implementing some striping RAID-1 on it and try that new module out, but if kernel 2.6 does not support PATA on the TX2-plus then I am at a loss.
best regards
Keld
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Quoted 6 lines · Keld Jørn Simonsen
I am running linux kernel 2.4.22-26mdk and it supports PATA right out of the box, on a Promise TX2-plus controller. I have one disk on the PATA port (and one disk on one of the SATA ports). I would probably like to run kernel 2.6, mostly because I think of implementing some striping RAID-1 on it and try that new module out, but if kernel 2.6 does not support PATA on the TX2-plus then I am at a loss.
It sounds like Mandrake added a non-standard Promise driver... Consult your vendor in this case.
Jeff
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Quoted 11 lines · Jeff Garzik
Quoted 6 lines · Keld Jørn Simonsen
I am running linux kernel 2.4.22-26mdk and it supports PATA right out of the box, on a Promise TX2-plus controller. I have one disk on the PATA port (and one disk on one of the SATA ports). I would probably like to run kernel 2.6, mostly because I think of implementing some striping RAID-1 on it and try that new module out, but if kernel 2.6 does not support PATA on the TX2-plus then I am at a loss.
It sounds like Mandrake added a non-standard Promise driver... Consult your vendor in this case.
I don't get this. Promise themselves say that TX2-plus is supported in Redhat 7.3/8.0 and SuSE 7.3/8.0 in their data sheet:
http://www.promise.com/marketing/datasheet/file/SATA150_DS_101703.pdf
I read that to be that support is included in the standard kernel, and has been for a long time, so it is a very stable driver, and standard. But of cause I may be mistaken.
But you say that the standard 2.4 and 2.6 driver is not implementing PATA. I am courious about the status of this. Are we talking the same controller?
Best regards
keld
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html