U-BOOT for MPC860T customized board
I have customised board with MPC860T,16MBytes of flash,16MBytes of SDRAM and ethernet interface.
CS0 is using for flash and CS1 is for SDRAM.
is there any standard board with this configuration.
so,that i can use that board configuration for U-BOOT.
thanking you
Ramana
Quoted 6 lines · In message <403F04E7.000003.01996@RAMANAYV> you wrote:
I have customised board with MPC860T,16MBytes of flash,16MBytes of SDRAM and ethernet interface.
CS0 is using for flash and CS1 is for SDRAM.
is there any standard board with this configuration.
There are far too many similar boards to mention.
Quoted 1 line
so,that i can use that board configuration for U-BOOT.
How should we know? Do don't provide any details. MPC860T: running at which CPU clock frequency? - which bus clock frequency? - with or without 32 kHz clock? Flash: which manufacturer? - which type? - how many chips ? - which bus width? SDRAM: which manufacturer? - which
type? - how many chips ? - which bus width? SDRAM: which
manufacturer? - which type? - how many chips ? - which bus width?
Ethernet: on SCC or FEC? - which PHY? ...
Sorry, but this is something which requires intimate knowledge of your hardware, and thus it can be done only by you.
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de Due to lack of disk space, this fortune database has been discontinued.