One tc filter police for 2 subnets
I´d like to limit input traffic from 2 subnets. Ex. 128Kbps for the two
subnets: 10.0.0.0/24 10.0.1.0/24
Like:
tc filter add dev eth3 parent ffff: protocol ip prio 5 u32 match ip src 10.0.0.0/24 ; 10.0.1.0/24 police rate 128kbit burst 10k drop flowid :1
Obviously this command did not work because tc does not accept two subnets as src separeted by ";".
Is there a way of doing this ?
Thanks a lot,
Luciano Lima
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Hello,
Quoted 8 lines
Like:
tc filter add dev eth3 parent ffff: protocol ip prio 5 u32 match ip src 10.0.0.0/24 ; 10.0.1.0/24 police rate 128kbit burst 10k drop flowid :1Obviously this command did not work because tc does not accept two subnets as src separeted by ";".
Is there a way of doing this ?
Sure, 10.0.0.0/24 and 10.0.1.0/24 can be aggregated as 10.0.0.0/23. This might have been only an example of yours but if you have adjacent netblocks, you can often aggregate them iff they match into a given netmask.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/