Skip to contentSkip to conversation

two WANs one LAN

LARTC Bob Beers 2 participants 2 messages Apr 20, 2004 – Apr 21, 2004

lore
Share & tools
lore

Bob Beers

author
#0 lore raw
Quoted 4 lines · Bob Beers

But I've done something wrong, obviously(?).

I suspect a typo or other oversight, but haven't found it yet.

Ok, after re-checking the cabling ( <- error here), and
re-checking the commands (verbatim from the nano.txt) it does work! (in my static ethernet setup). Great stuff!

Will it be the same when I introduce the dynamic ppp0 for IFE1? The IPE1 will be a NAT'd public IP, but the GWE1 will be
the P-t-P link.

Also, what steps can be taken to expedite the detection and
route adjustment?
Is it enough to decrease the sleep time in the ping_daemon? Are there some /proc/sys/.../whatever that can/should be tweaked?

Thanks for any help.

Signature · 6 lines
Bob Beers


_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#1 lore raw
Quoted 3 lines · Bob Beers

Will it be the same when I introduce the dynamic ppp0 for IFE1? The IPE1 will be a NAT'd public IP, but the GWE1 will be
the P-t-P link.

If you use the correct syntax, yes. Something like
ip addr add IP/MASK peer BROADCAST dev PPP0
substituting the point-to-point remote IP for BROADCAST and the correct device for PPP0 (IIRC. Sorry, it has been a long time. Regardless, the keyword here is "peer".)

Quoted 2 lines

Also, what steps can be taken to expedite the detection and
route adjustment?

Flush the cache. Again, IIRC
ip route flush
but a search of the archive will turn up the correct command. If you can arrange it, a remote computer pinging each IP and messaging you when the ping fails can be used to trigger the flush. Otherwise, "ping -c 1 -I PPP0 IP" (alternate between the devices for each ping) internally is about the best you can do; ping NEVER failed for me (see below) but YMMV.

Quoted 1 line

Is it enough to decrease the sleep time in the ping_daemon?

No help at all. AFAIC, less often is better, not worse.

Quoted 1 line

Are there some /proc/sys/.../whatever that can/should be tweaked?

Nope. And nothing anywhere else, either. DGD is _very_ hard because usually the next hop is OK, it is the one after it that is bad. I don't think that even Julian can deal with "next in the route is OK but his peer is dead". In my case, the net card could speak just fine to the DSL router; it was the modem (router) that could not I/O because it was dead. Of course, DGD knew the modem was OK so it thought the link was alive...

gypsy
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/