Skip to contentSkip to conversation

[2.6.6] eepro100 vs e100?

DISCUSSION Jan De Luyck 6 participants 6 messages May 19, 2004 – May 22, 2004

lore
Share & tools
lore
#0 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hello List,

I'm currently in the process of cleaning up my 2.6 kernel configuration on my trusty SMP HP Netserver LC3, which comes shipped with 2 identical intel Pro Ethernet 100 mbit cards:

0000:00:08.0 Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100] (rev 05)
Subsystem: Hewlett-Packard Company NetServer 10/100TX
Flags: bus master, medium devsel, latency 66, IRQ 16 Memory at fecfd000 (32-bit, prefetchable)
I/O ports at fcc0 [size=32]
Memory at fed00000 (32-bit, non-prefetchable) [size=1M]
Capabilities: [dc] Power Management version 1

I'm wondering what driver is the "best" one to use? Judging by the comments in the files, the e100 driver seems to be the best maintained, though I'm probably wrong ;p

The website that is referenced in the eepro100 driver is no longer available (returns a 404).

If someone can shed some light on this, thanks!

Jan
- --
Sanity is the trademark of a weak mind.
-- Mark Harrold
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQFAqwWhUQQOfidJUwQRAt7wAJ9H/wapw68XfrYHgV44tf4MfqIUeACdFBvF R4Aupx+q9AlCKEWjtAE2v2c=
=jQHj
-----END PGP SIGNATURE-----

#1 lore raw
Quoted 3 lines · Jan De Luyck

I'm wondering what driver is the "best" one to use? Judging by the comments in the files, the e100 driver seems to be the best maintained, though I'm probably wrong ;p

We have a usenet server we use with 2.6.6 kernel and the eepro100 gives IRQ problems:

May 16 01:35:58 enterprise kernel: eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
May 16 01:35:58 enterprise kernel: eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <[email protected]> and others
May 16 01:35:58 enterprise kernel: eth0: OEM i82557/i82558 10/100 Ethernet, 00:90:27:BE:B6:85, IRQ 18.
May 16 01:35:58 enterprise kernel:   Board assembly 734938-001, Physical connectors present: RJ45
May 16 01:35:58 enterprise kernel:   Primary interface chip i82555 PHY #1.
May 16 01:35:58 enterprise kernel:   General self-test: passed.
May 16 01:35:58 enterprise kernel:   Serial sub-system self-test: passed.
May 16 01:35:58 enterprise kernel:   Internal registers self-test: passed.
May 16 01:35:58 enterprise kernel:   ROM checksum self-test: passed (0x04f4518b).
May 16 01:35:58 enterprise kernel: eth0: freeing mc frame.
May 16 01:47:12 enterprise kernel: eth0: TX underrun, threshold adjusted.
May 16 01:47:27 enterprise last message repeated 26 times

Where as the e100 is rocksolid (knock wood) under sometimes heavy load:

Linux 2.6.6-bk2 (root@enterprise) (gcc 3.3.3 ) #1 Sun May 16 10:50:59 CEST 2004 1CPU [enterprise.cistron.nl]

Memory:      Total        Used        Free      Shared     Buffers      
Mem:       1037228     1031548        5680           0      624540
Swap:      1027144        9424     1017720

Bootup: Sun May 16 11:34:58 2004 Load average: 1.88 1.77 1.69 5/87 9230

user  :       6:03:53.43   8.7%  page in :        0
nice  :       0:51:24.39   1.2%  page out:        0
system:       9:22:34.92  13.5%  swap in :        0
idle  :      12:48:17.34  18.4%  swap out:        0
uptime:   2d 21:35:04.35         context :483979334
irq  0: 250377255 timer                 irq 12:         3                      
irq  1:         3                       irq 14:  11055492 ide0                 
irq  3:         2                       irq 15:  11058878 ide1                 
irq  4:       193 serial                irq 16:  27773698 sym53c8xx            
irq  8:         3 rtc                   irq 18: 996592375 eth0                 
irq  9:         0 acpi                  irq 19:  22025755 ide2, ide3    

So _i_ would advise the e100 driver.

Danny
(personal view etc)

Signature · 4 lines
 /"\                        | Dying is to be avoided because
 \ /  ASCII RIBBON CAMPAIGN | it can ruin your whole career 
  X   against HTML MAIL     | 
 / \  and POSTINGS          | - Bob Hope
#2 lore raw
In reply to Jan De Luyck

JDL> I'm wondering what driver is the "best" one to use? Judging by the comments in JDL> the files, the e100 driver seems to be the best maintained, though I'm JDL> probably wrong ;p

I would suggest e100 from practice. The onboard Ethernet of Intel D815EEA2 mainboard works fine in 100Mb/FD with both drivers but started acting strangely in 10Mb/HD network with eepro100 (e100 seems to be OK).

Signature · 1 line
Meelis Roos
#3 lore raw
In reply to Jan De Luyck

I've always had good results with the e100 driver:

Intel(R) PRO/100 Network Driver - version 2.3.36-k1 Copyright (c) 2003 Intel Corporation

e100: selftest OK.
e100: eth1: Intel(R) PRO/100 Network Connection
Hardware receive checksums enabled
cpu cycle saver enabled

Quoted 39 lines · Jan De Luyck

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hello List,

I'm currently in the process of cleaning up my 2.6 kernel configuration on my trusty SMP HP Netserver LC3, which comes shipped with 2 identical intel Pro Ethernet 100 mbit cards:

0000:00:08.0 Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100] (rev 05)
Subsystem: Hewlett-Packard Company NetServer 10/100TX
Flags: bus master, medium devsel, latency 66, IRQ 16
Memory at fecfd000 (32-bit, prefetchable)
I/O ports at fcc0 [size=32]
Memory at fed00000 (32-bit, non-prefetchable) [size=1M]
Capabilities: [dc] Power Management version 1

I'm wondering what driver is the "best" one to use? Judging by the comments in the files, the e100 driver seems to be the best maintained, though I'm probably wrong ;p

The website that is referenced in the eepro100 driver is no longer available (returns a 404).

If someone can shed some light on this, thanks!

Jan
- --
Sanity is the trademark of a weak mind.
-- Mark Harrold
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQFAqwWhUQQOfidJUwQRAt7wAJ9H/wapw68XfrYHgV44tf4MfqIUeACdFBvF R4Aupx+q9AlCKEWjtAE2v2c=
=jQHj
-----END PGP SIGNATURE-----
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

#4 lore raw
In reply to Jan De Luyck
Quoted 1 line · Jan De Luyck

I'm currently in the process of cleaning up my 2.6 kernel configuration on my trusty SMP HP Netserver LC3, which comes shipped with 2 identical intel Pro Ethernet 100 mbit cards:

While initially there did seem to be lockups with multiple e100 devices, I haven't seen that in some versions. I have several servers which run the NICs at 70-80 Mbit all the time and see no issues with the e100 at this time.

Signature · 3 lines
bill davidsen <[email protected]>
  CTO TMR Associates, Inc
  Doing interesting things with small computers since 1979
#5 lore raw
In reply to Jan De Luyck
Quoted 2 lines · Jan De Luyck

Hello List,

[snip]

Quoted 3 lines

The website that is referenced in the eepro100 driver is no longer available (returns a 404).

There seems to be some maintenance going on there see:
http://www.scyld.com/network.html

--------------------------------------------------
Darren Williams <dsw AT gelato.unsw.edu.au>
Gelato@UNSW <www.gelato.unsw.edu.au>
--------------------------------------------------