Skip to contentSkip to conversation

to get I2O working with Adaptec's zero channel controllers (ASR-2000S, ASR-2005S, ASR-2010S and ASR-2015S)

PATCH In review Markus Lidel 2 participants 2 messages May 25, 2004 – May 27, 2004 SCSI

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 to get I2O working with Adaptec's zero channel controllers (ASR-2000S, ASR-2005S, ASR-2010S and ASR-2015S)

Hello,

the patch should get the mentioned controllers working with the I2O subsystem. Because we have no hardware to test it on, it would be great, if someone could give it a try and report if it works or not.

We've tested it on i686 and x86_64 with already working I2O controllers without a problem.

Thank you very much.

Best regards,

Markus Lidel
------------------------------------------
Markus Lidel (Senior IT Consultant)

Shadow Connect GmbH
Carl-Reisch-Weg 12
D-86381 Krumbach
Germany

Phone:  +49 82 82/99 51-0
Fax:    +49 82 82/99 51-11
E-Mail: [email protected]
URL:    http://www.shadowconnect.com
drivers/message/i2o/i2o_block.c +4 -4
@@ -280,8 +280,8 @@
 {
 	struct i2o_controller *c = dev->controller;
 	int tid = dev->tid;
-	unsigned long msg;
-	unsigned long mptr;
+	void *msg;
+	void *mptr;
 	u64 offset;
 	struct request *req = ireq->req;
 	int count = req->nr_sectors<<9;
@@ -291,7 +291,7 @@
 
 	// printk(KERN_INFO "i2ob_send called\n");
 	/* Map the message to a virtual address */
-	msg = c->mem_offset + m;
+	msg = c->msg_virt + m;
 	
 	sgnum = i2ob_build_sglist(dev, ireq);
 	
@@ -479,7 +479,7 @@
 		/* Now flush the message by making it a NOP */
 		m[0]&=0x00FFFFFF;
 		m[0]|=(I2O_CMD_UTIL_NOP)<<24;
-		i2o_post_message(c, ((unsigned long)m) - c->mem_offset);
+		i2o_post_message(c, (unsigned long) m - (unsigned long) c->msg_virt);
 
 		return;
 	}
drivers/message/i2o/i2o_config.c +1 -1
@@ -97,7 +97,7 @@
 	u32 *msg = (u32 *)m;
 
 	if (msg[0] & MSG_FAIL) {
-		u32 *preserved_msg = (u32*)(c->mem_offset + msg[7]);
+		u32 *preserved_msg = (u32*)(c->msg_virt + msg[7]);
 
 		printk(KERN_ERR "i2o_config: IOP failed to process the msg.\n");
 
drivers/message/i2o/i2o_core.c +100 -53

257 lines not on this page · raw message

drivers/message/i2o/i2o_scsi.c +3 -3
@@ -659,7 +659,7 @@
 	if(m==0xFFFFFFFF)
 		return 1;
 
-	msg = (u32 *)(c->mem_offset + m);
+	msg = (u32 *)(c->msg_virt + m);
 	
 	/*
 	 *	Put together a scsi execscb message
@@ -936,7 +936,7 @@
 	struct Scsi_Host *host;
 	struct i2o_scsi_host *hostdata;
 	u32 m;
-	unsigned long msg;
+	void *msg;
 	unsigned long timeout;
 
 	
@@ -974,7 +974,7 @@
 	while(time_before(jiffies, timeout));
 	
 	
-	msg = c->mem_offset + m;
+	msg = c->msg_virt + m;
 	i2o_raw_writel(FOUR_WORD_MSG_SIZE|SGL_OFFSET_0, msg);
 	i2o_raw_writel(I2O_CMD_SCSI_BUSRESET<<24|HOST_TID<<12|tid, msg+4);
 	i2o_raw_writel(scsi_context|0x80000000, msg+8);
include/linux/i2o.h +9 -5
@@ -99,6 +99,7 @@
 	int		irq;
 	int		short_req:1;	/* Use small block sizes        */
 	int		dpt:1;		/* Don't quiesce                */
+	int		raptor:1;	/* split bar                    */
 	int		promise:1;	/* Promise controller		*/
 #ifdef CONFIG_MTRR
 	int		mtrr_reg0;
@@ -109,9 +110,9 @@
 	atomic_t users;
 	struct i2o_device *devices;		/* I2O device chain */
 	struct i2o_controller *next;		/* Controller chain */
-	unsigned long post_port;		/* Inbout port address */
-	unsigned long reply_port;		/* Outbound port address */
-	unsigned long irq_mask;			/* Interrupt register address */
+	void *post_port;			/* Inbout port address */
+	void *reply_port;			/* Outbound port address */
+	void *irq_mask;				/* Interrupt register address */
 
 	/* Dynamic LCT related data */
 	struct semaphore lct_sem;
@@ -128,8 +129,11 @@
 	dma_addr_t hrt_phys;
 	u32 hrt_len;
 
-	unsigned long mem_offset;		/* MFA offset */
-	unsigned long mem_phys;			/* MFA physical */
+	void *base_virt;			/* base virtual address */
+	unsigned long base_phys;		/* base physical address */
+
+	void *msg_virt;				/* messages virtual address */
+	unsigned long msg_phys;			/* messages physical address */
 
 	int battery:1;				/* Has a battery backup */
 	int io_alloc:1;				/* An I/O resource was allocated */
#1 lore raw

not my 2010s. it is not found at all. I send details to markus as a direct mail (sample config, dmesg, lspci -vvv).

Does anyone else have success using this patch? (I used it with kernel 2.6.7-rc1 btw, I hope that was ok?)

Regards, Andreas