OMAP1610 cs boot mode

Hi,

I included a patch that adds support for CS boot mode recognition on OMAP1610 Innovator and H2 boards.
Currently you have to build U-Boot either for CS0 or CS3 boot mode. The patch adds new make targets for binaries that will check the boot mode and set flash address accordingly. Also some board specific init steps are skipped when booting from RAM.
The new targets are:
omap1610h2_cs_autoboot_config omap1610inn_cs_autoboot_config

Imre
-------------- next part --------------
A non-text attachment was scrubbed...
Name: patch-u-boot-1.1.1-omap
Type: application/octet-stream
Size: 9842 bytes
Desc: patch-u-boot-1.1.1-omap
Url : http://lists.denx.de/pipermail/u-boot/attachments/20040526/b81d5deb/attachment.obj

Please explain where the name "autoboot" comes from.

Best regards,

Wolfgang Denk

Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Certainly there are things in life that money  can't  buy,  but  it's
very funny - Did you ever try buying them without money? - Ogden Nash

Thanks, added - except for the part which modifies common/env_flash.c

Here, instead of simply initializing the relevant variables at compile time, you added code to do this at run time. I don't think this is a good idea. Please explain why you are doing this, and which problem you attempt to fix.

Best regards,

Wolfgang Denk

Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
THIS IS A 100% MATTER  PRODUCT:  In  the  Unlikely  Event  That  This
Merchandise  Should  Contact  Antimatter  in Any Form, a Catastrophic
Explosion Will Result.