Skip to contentSkip to conversation

Is it possible to control uplink in a NATted environment

LARTC Logu 2 participants 2 messages Jun 8, 2004 – Jun 9, 2004

lore
Share & tools
lore

Logu

author
#0 lore raw

Hi all,

Given below ia the simple network diagram. I need to control uplink for the individual private network IPs as depicted in the diagram. Is this possible in a NATed environment using CBQ or HTB. I learnt that we can control only outgoing traffic. So if I control in the eth1 interface the source IP will be masqueraded, and it may not result in the desired behaviour.

Is there a solution to address this issue.

GATEWAY

private net work |-----------|
-------------------| |------------------------Internet

                      eth0 |-----------| eth1 NAT

Thanks
-logu

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw

Hi Logu,

Quoted 4 lines

So if I control in the eth1 interface the source IP will be masqueraded, and it may not result in the desired behaviour.

Is there a solution to address this issue.

You can use iptables to set different marks on the packets, and then filter based on those marks.

regards,

Signature · 10 lines
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Damion de Soto - Software Engineer  email:     [email protected]
SnapGear - A CyberGuard Company ---    ph:         +61 7 3435 2809
  | Custom Embedded Solutions          fax:         +61 7 3891 3630
  | and Security Appliances            web: http://www.snapgear.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
  ---  Free Embedded Linux Distro at   http://www.snapgear.org  ---
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/