bootm NIOS
Hi,
I am trying to get the "bootm" command for the Nios architecture on the Stratix Board running. I can start uClinux with the "go" command, but no matter what I try, there is no way to get it working with the "bootm" command. I tried to implement it in the file lib_nios/nios_linux.c like the "go" command without any command line passing and other stuff. The only printout I get is the following:
DK1S10 > bootm 1000100
## Booting image at 01000100 ...
Image Name: Linux Kernel Image
Image Type: Nios-32 Linux Kernel Image (uncompressed)
Data Size: 974592 Bytes = 951.8 kB Load Address: 01000100
Entry Point: 01000100
Verifying Checksum ... OK
XIP Kernel Image ... OK
Any hints or ideas?
Thanks in advance
Thomas
Quoted 3 lines · In message <[email protected]> you wrote:
I am trying to get the "bootm" command for the Nios architecture on the Stratix Board running. I can start uClinux with the "go" command, but no
...
Quoted 1 line
The only printout I get is the following:
...
Quoted 1 line
XIP Kernel Image ... OK
Is this REALLY an XIP image? Probably you're executing a branch of code which you don't really want to use.
Best regards,
Wolfgang Denk
Signature · 5 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de
There's a way out of any cage.
-- Captain Christopher Pike, "The Menagerie" ("The Cage"),
stardate unknown.Quoted 9 lines · Wolfgang Denk
Quoted 3 lines · In message <[email protected]> you wrote:
I am trying to get the "bootm" command for the Nios architecture on the Stratix Board running. I can start uClinux with the "go" command, but no
...
Quoted 2 lines
The only printout I get is the following:
Quoted 7 lines
...
Quoted 2 lines
XIP Kernel Image ... OK
Is this REALLY an XIP image? Probably you're executing a branch of code which you don't really want to use.
That was the problem. Linux is starting now. Thanks a lot.
Thomas