Typing error: s/IA32/IA-32/
PATCH 1/1 Typing error: s/IA32/IA-32/
IA32 is wrong according to Intel.
Signature · 3 lines
Address: Daniel Baumann, Burgunderstrasse 3, CH-4562 Biberist Email: [email protected] Internet: http://people.panthera-systems.net/~daniel-baumann/
CREDITS +1 -1
@@ -41,7 +41,7 @@ E: [email protected] W: http://www.moses.uklinux.net/patches D: BFS filesystem -D: Intel IA32 CPU microcode update support +D: Intel IA-32 CPU microcode update support D: Various kernel patches S: United Kingdom
Documentation/Changes +3 -3
@@ -202,10 +202,10 @@ newer has this support. Use the recommended version or newer from the table above. -Intel IA32 microcode --------------------- +Intel IA-32 microcode +--------------------- -A driver has been added to allow updating of Intel IA32 microcode, +A driver has been added to allow updating of Intel IA-32 microcode, accessible as both a devfs regular file and as a normal (misc) character device. If you are not using devfs you may need to:
Documentation/ioctl-number.txt +1 -1
@@ -77,7 +77,7 @@ '#' 00-3F IEEE 1394 Subsystem Block for the entire subsystem '1' 00-1F <linux/timepps.h> PPS kit from Ulrich Windl <ftp://ftp.de.kernel.org/pub/linux/daemons/ntp/PPS/> -'6' 00-10 <asm-i386/processor.h> Intel IA32 microcode update driver +'6' 00-10 <asm-i386/processor.h> Intel IA-32 microcode update driver <mailto:[email protected]> '8' all SNP8023 advanced NIC card <mailto:[email protected]>
arch/i386/Kconfig +6 -6
@@ -95,7 +95,7 @@ config X86_VISWS bool "SGI 320/540 (Visual Workstation)" help - The SGI Visual Workstation series is an IA32-based workstation + The SGI Visual Workstation series is an IA-32-based workstation based on SGI systems chips with some legacy PC hardware attached. Say Y here to create a kernel to run on the SGI 320 or 540.
@@ -111,11 +111,11 @@ It is intended for a generic binary kernel. config X86_ES7000 - bool "Support for Unisys ES7000 IA32 series" + bool "Support for Unisys ES7000 IA-32 series" depends on SMP help Support for Unisys ES7000 systems. Say 'Y' here if this kernel is - supposed to run on an IA32-based Unisys ES7000 system. + supposed to run on an IA-32-based Unisys ES7000 system. Only choose this option if you have such a system, otherwise you should say N here.
@@ -622,11 +622,11 @@ Say N otherwise. config MICROCODE - tristate "/dev/cpu/microcode - Intel IA32 CPU microcode support" + tristate "/dev/cpu/microcode - Intel IA-32 CPU microcode support" ---help--- If you say Y here and also to "/dev file system support" in the 'File systems' section, you will be able to update the microcode on - Intel processors in the IA32 family, e.g. Pentium Pro, Pentium II, + Intel processors in the IA-32 family, e.g. Pentium Pro, Pentium II, Pentium III, Pentium 4, Xeon etc. You will obviously need the actual microcode binary data itself which is not shipped with the Linux kernel.
@@ -684,7 +684,7 @@ If more than 4 Gigabytes is used then answer "64GB" here. This selection turns Intel PAE (Physical Address Extension) mode on. - PAE implements 3-level paging on IA32 processors. PAE is fully + PAE implements 3-level paging on IA-32 processors. PAE is fully supported by Linux, PAE mode is implemented on all recent Intel processors (Pentium Pro and better). NOTE: If you say "64GB" here, then the kernel will not boot on CPUs that don't support PAE!
arch/x86_64/Kconfig +3 -3
@@ -95,7 +95,7 @@ config MPSC bool "Intel x86-64" help - Optimize for Intel IA32 with 64bit extension CPUs + Optimize for Intel IA-32 with 64bit extension CPUs (Prescott/Nocona/Potomac) config GENERIC_CPU
@@ -361,14 +361,14 @@ source "fs/Kconfig.binfmt" config IA32_EMULATION - bool "IA32 Emulation" + bool "IA-32 Emulation" help Include code to run 32-bit programs under a 64-bit kernel. You should likely turn this on, unless you're 100% sure that you don't have any 32-bit programs left. config IA32_AOUT - bool "IA32 a.out support" + bool "IA-32 a.out support" depends on IA32_EMULATION help Support old a.out binaries in the 32bit emulation.