Skip to contentSkip to conversation

2.6.9-rc3 software suspend (pmdisk) stopped working

DISCUSSION Mitch 2 participants 2 messages Oct 3, 2004

lore
Share & tools
lore

Mitch

author
#0 lore raw

Hi Jesse,

as shown below, that is not one of the options presented to me in my 'disk' file

% cat /sys/power/disk
shutdown

My machine can only use the shutdown keyword - which worked in -rc3.

Mitch

-------- Original Message --------
Subject: Re: 2.6.9-rc3 software suspend (pmdisk) stopped working
Date: Sun, 03 Oct 2004 09:12:52 -0400
From: Jesse <[email protected]>
To: Mitch <[email protected]>
CC: [email protected], [email protected]
References: <[email protected]>

Quoted 5 lines · Mitch

Hi,

Ok, here is the kernel messages attached. Nothing of real value in it as far as i can see (even with PM_DEBUG on), but you may spot something. Basically the suspend process appears to start but the machine is never powered off and the resume kernel routines are run immediately bringing the kernel/system back to it's resumed state. The *same* kernel config works on -rc2. If i hard power off the machine then i have to fsck my disks on bootup (as expected) and the suspended image is not loaded. Clearly the latest patches have broken something but what ? Can anyone else without ACPI suspend on -rc3 ?

It's working for me on my Thinkpad 600x (ACPI is not compiled in) Used 'reboot' command from Documentation.power/swsusp.txt

Jesse

#1 lore raw
Quoted 7 lines · Mitch

Hi Jesse,

as shown below, that is not one of the options presented to me in my 'disk' file

% cat /sys/power/disk
shutdown

My machine shows the same thing. Only shutdown in /sys/power/disk

Grab the code from Documentation/power/swsusp.txt (starts at line 151)

I compiled it to an executable called swsusp and I then run 'swsusp' to start the suspend process.

2.6.9-rc3 was my first attempt at suspend, and it worked as designed on the first try.

Jesse