MMC power cycle
PATCH 1/1 MMC power cycle
I think I've found the special magic required to initialise my problem card without causing issues with other cards/controllers.
After the initial scan to determine a correct voltage, the host cycles power to reboot any cards (like mine) that have gone into shutdown. This patch works with the two cards I have (one good, one bad).
Russell, do you think this will work in all discussed scenarios?
Rgds
Pierre
drivers/mmc/mmc.c +15 -4
@@ -666,13 +666,24 @@ host->ocr =mmc_select_voltage (host, ocr);/* -* Since we're changing the OCR value, we seem to -* need to tell some cards to go back to the idle -* state. We wait 1ms to give cards time to -* respond. +* Some cards shut down when receiving an OCR of +* zero. But since they send their mask before +* shutting down we can still calculate a correct +* voltage. To get them back to life we need to +* cycle power. +* +* When changing OCR values we also need to put +* the cards in idle state. But since we restart +* them here that point is moot. */ if (host->ocr) + { +mmc_power_off (host); +mmc_delay (100 ); +mmc_power_up (host); +mmc_idle_cards (host); + } }else { host->ios.bus_mode =MMC_BUSMODE_OPENDRAIN ; host->ios.clock = host->f_min;