Skip to contentSkip to conversation

2.6.9-rc3-mm3 woes

DISCUSSION Clemens Schwaighofer 3 participants 5 messages Oct 11, 2004

lore
Share & tools
lore
#0 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,

System: debian/unstable

I just tried 2.6.9-rc3-mm3 and I have two problems:

- - he calls himself 2.6.9-rc-mm31, yeah 31. I don't know where this comes from, because in the Makefile itself it is mm3. Whatever makes him do that, I don't know, but he install himselfs like this, perhaps the problems come from that

- - cdrecord segfaults. Again I don't know if this is cdrecords fault or not, but cdrecord works fine with 2.6.9-rc2-mm1

If needed I provide the kernel config.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.5 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFBafy1jBz/yQjBxz8RAlrEAKCh1iS4T96fsVlQaq5cr1PNIHQzMQCgsf3r Wt97FUJOzgxjRVSRfP8NCJ0=
=UnNu
-----END PGP SIGNATURE-----

#1 lore raw
Quoted 9 lines · Clemens Schwaighofer

System: debian/unstable

I just tried 2.6.9-rc3-mm3 and I have two problems:

- - he calls himself 2.6.9-rc-mm31, yeah 31. I don't know where this comes from, because in the Makefile itself it is mm3. Whatever makes him do that, I don't know, but he install himselfs like this, perhaps the problems come from that

Weird. Works fine here. Maybe this is a bug in the debian build process, try building from a fresh tree.

Quoted 3 lines

- - cdrecord segfaults. Again I don't know if this is cdrecords fault or not, but cdrecord works fine with 2.6.9-rc2-mm1

You might need to back out this patch:

ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.9-rc3/2.6.9-rc3-mm3/broken-out/optimize-profile-path-slightly.patch

HTH,

Lee

#2 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Quoted 13 lines · Lee Revell
Quoted 9 lines · Clemens Schwaighofer

System: debian/unstable

I just tried 2.6.9-rc3-mm3 and I have two problems:

- - he calls himself 2.6.9-rc-mm31, yeah 31. I don't know where this comes from, because in the Makefile itself it is mm3. Whatever makes him do that, I don't know, but he install himselfs like this, perhaps the problems come from that

Quoted 2 lines

Weird. Works fine here. Maybe this is a bug in the debian build process, try building from a fresh tree.

I'll build from kernel.org vanilla 2.8.1 + rc3 + mm3 patch.

Quoted 7 lines
Quoted 3 lines

- - cdrecord segfaults. Again I don't know if this is cdrecords fault or not, but cdrecord works fine with 2.6.9-rc2-mm1

You might need to back out this patch:

ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.9-rc3/2.6.9-rc3-mm3/broken-out/optimize-profile-path-slightly.patch

oh thanks. I'll try that.

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.5 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFBapIOjBz/yQjBxz8RAjqyAJ9trl/eSGibfYIi6m0JggVK56IZCgCfWztG yhT4j2QQy4c+p3Uk5c7ntD0=
=NBMG
-----END PGP SIGNATURE-----

#3 lore raw
In reply to Clemens Schwaighofer
Quoted 11 lines · On Mon, 11 Oct 2004 12:23:33 +0900 Clemens Schwaighofer <[email protected]>…

Hi,

System: debian/unstable

I just tried 2.6.9-rc3-mm3 and I have two problems:

- - he calls himself 2.6.9-rc-mm31, yeah 31. I don't know where this comes from, because in the Makefile itself it is mm3. Whatever makes him do that, I don't know, but he install himselfs like this, perhaps the problems come from that

Hello, I had something like that happen the other day because without paying attention, I said 'n' to the question of "Local version - append to kernel release" during oldconfig instead of leaving it blank. It was 2.6.9-rc3n

Check to make sure you haven't done something similar (it's under General Setup).

#4 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Quoted 7 lines · Mike Houston

Hello, I had something like that happen the other day because without paying attention, I said 'n' to the question of "Local version - append to kernel release" during oldconfig instead of leaving it blank. It was 2.6.9-rc3n

Check to make sure you haven't done something similar (it's under General Setup).

OH! hehe, that comes when you make oldconfig, and just don't read new stuff in detail. Thanks a lot, I would have never found that ... -----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.5 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFBapJIjBz/yQjBxz8RAp/bAJ9uBjVhHOjKAWgH5ly6ZbyKOHrbDACeNoj4 lrMlo1Z3MA9aSTV8L4quvLM=
=dzId
-----END PGP SIGNATURE-----