Skip to contentSkip to conversation

unsupported USB/IDE bridge?

DISCUSSION Jan Evert van Grootheest 1 participant 1 message Nov 26, 2004

lore
Share & tools
lore
#0 lore raw

Hi,

I bought an USB/IDE bridge and put a DVD-RW in it. Now if I plug it in, it gets assigned /dev/sda by the kernel. Not bad at all, I thought. And it reads CDs and DVDs just fine.
But, unfortunately, I can't (yet) write with it.
Checking the logs I found the lines below when re-plugging it.

Those lines request mailing here.

Some other info: this is a Duron 700 running debians 2.6.9-1-k7 kernel. Udev and hotplug are (according to dpkg):

ii  udev                    0.042-1                 /dev/ management daemon
ii  hotplug                 0.0.20040329-16         Linux Hotplug Scripts

If any other information is required, just ask.

While I'm here, any suggestions how to get this DVD writing?

Thanks,
Jan Evert

Nov 26 13:55:15 quark kernel: usb 1-2: new high speed USB device using 
address 3
Nov 26 13:55:15 quark kernel: scsi1 : SCSI emulation for USB Mass 
Storage devices
Nov 26 13:55:15 quark kernel:   Vendor: Revoltec  Model: USB/IDE Bridge 
(  Rev: 0103
Nov 26 13:55:15 quark kernel:   Type:   Direct-Access 
    ANSI SCSI revision: 02
Nov 26 13:55:15 quark kernel: sda : READ CAPACITY failed.
Nov 26 13:55:15 quark kernel: sda : status=0, message, host=7, driver
Nov 26 13:55:15 quark kernel: sda : sense not available.
Nov 26 13:55:15 quark kernel: sda: assuming Write Enabled
Nov 26 13:55:15 quark kernel: sda: assuming drive cache: write through
Nov 26 13:55:15 quark kernel: sda : READ CAPACITY failed.
Nov 26 13:55:15 quark kernel: sda : status=0, message, host=7, driver
Nov 26 13:55:15 quark kernel: sda : sense not available.
Nov 26 13:55:15 quark kernel: sda: assuming Write Enabled
Nov 26 13:55:15 quark kernel: sda: assuming drive cache: write through
Nov 26 13:55:15 quark kernel: sda : READ CAPACITY failed.
Nov 26 13:55:15 quark kernel: sda : status=0, message, host=7, driver
Nov 26 13:55:15 quark kernel: sda : sense not available.
Nov 26 13:55:15 quark kernel: sda: assuming Write Enabled
Nov 26 13:55:15 quark kernel: sda: assuming drive cache: write through
Nov 26 13:55:15 quark kernel: 
/dev/scsi/host1/bus0/target0/lun0:<3>Buffer I/O error on device sda, 
logical block 0
Nov 26 13:55:15 quark kernel: Buffer I/O error on device sda, logical 
block 0
Nov 26 13:55:15 quark kernel:  unable to read partition table
Nov 26 13:55:15 quark kernel: 
/dev/scsi/host1/bus0/target0/lun0:<3>Buffer I/O error on device sda, 
logical block 0
Nov 26 13:55:15 quark kernel:  unable to read partition table
Nov 26 13:55:15 quark kernel: Attached scsi removable disk sda at scsi1, 
channel 0, id 0, lun 0
Nov 26 13:55:15 quark kernel: USB Mass Storage device found at 3
Nov 26 13:55:16 quark scsi.agent[4298]: disk at 
/devices/pci0000:00/0000:00:13.2/usb1/1-2/1-2:1.0/host1/1:0:0:0
Nov 26 13:55:16 quark kernel: usb 1-2: USB disconnect, address 3
Nov 26 13:55:16 quark kernel: ehci_hcd 0000:00:13.2: qh d6875080 (#0) 
state 1
Nov 26 13:55:16 quark kernel: usb 1-2: new high speed USB device using 
address 4
Nov 26 13:55:16 quark kernel: scsi2 : SCSI emulation for USB Mass 
Storage devices
Nov 26 13:55:16 quark kernel:   Vendor: Revoltec  Model: USB/IDE Bridge 
(  Rev: 0103
Nov 26 13:55:16 quark kernel:   Type:   Direct-Access 
    ANSI SCSI revision: 02
Nov 26 13:55:16 quark kernel: SCSI device sda: 55208 2048-byte hdwr 
sectors (113 MB)
Nov 26 13:55:16 quark kernel: sda: assuming Write Enabled
Nov 26 13:55:16 quark kernel: sda: assuming drive cache: write through
Nov 26 13:55:20 quark wait_for_sysfs[4258]: either wait_for_sysfs (udev 

042) needs an update to handle the device '/devices/pci0000:00/0000:00:13.2/usb1/1-2/1-2:1.0' properly (no bus device link) or the sysfs-support of your device's driver needs to be fixed, please report to <[email protected]>

Nov 26 13:55:20 quark udev[4409]: creating device node '/dev/sda'
Nov 26 13:55:21 quark wait_for_sysfs[4284]: either wait_for_sysfs (udev 

042) needs an update to handle the device '/class/scsi_device/1:0:0:0' properly (no device symlink) or the sysfs-support of your device's driver needs to be fixed, please report to <[email protected]>

Nov 26 13:55:21 quark udev[4414]: removing device node '/dev/sda'
Nov 26 13:55:21 quark wait_for_sysfs[4378]: either wait_for_sysfs (udev 

042) needs an update to handle the device '/devices/pci0000:00/0000:00:13.2/usb1/1-2/1-2:1.0' properly (no bus device link) or the sysfs-support of your device's driver needs to be fixed, please report to <[email protected]>

Nov 26 13:55:21 quark kernel:  /dev/scsi/host2/bus0/target0/lun0: 
unknown partition table
Nov 26 13:55:21 quark kernel: Attached scsi removable disk sda at scsi2, 
channel 0, id 0, lun 0
Nov 26 13:55:21 quark kernel: USB Mass Storage device found at 4
Nov 26 13:55:21 quark udev[4450]: creating device node '/dev/sda'
Nov 26 13:55:23 quark usb.agent[4434]:      usb-storage: already loaded
Nov 26 13:55:23 quark logger: usb-storage started to add 402/5621/103
Nov 26 13:55:24 quark scsi.agent[4441]: disk at 
/devices/pci0000:00/0000:00:13.2/usb1/1-2/1-2:1.0/host2/2:0:0:0
Nov 26 13:55:24 quark usb.agent[4451]:      usb-storage: already loaded
Nov 26 13:55:24 quark logger: usb-storage started to add 402/5621/103

-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users. Discover which products truly live up to the hype. Start reading now.
http://productguide.itmanagersjournal.com/
_______________________________________________
Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net
[email protected]
https://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel