Skip to contentSkip to conversation

where to find very solid/stable Y-power connectors?

DISCUSSION Michael Stumpf 2 participants 2 messages Dec 10, 2004 MD RAID

lore
Share & tools
lore
#0 lore raw

Subject says it all. Separating this out from being buried in a prior thread. Has anyone found a source for very stable / not affected by jiggling molex Y-power splitters for drives?

--------------------------------------------
My mailbox is spam-free with ChoiceMail, the leader in personal and corporate anti-spam solutions. Download your free copy of ChoiceMail from www.choicemailfree.com

#1 lore raw
Quoted 4 lines · Michael Stumpf

Subject says it all. Separating this out from being buried in a prior thread. Has anyone found a source for very stable / not affected by jiggling molex Y-power splitters for drives?

Quoted 8 lines

--------------------------------------------
My mailbox is spam-free with ChoiceMail, the leader in personal and corporate anti-spam solutions. Download your free copy of ChoiceMail from www.choicemailfree.com

-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

Here's what to do:
Buy or borrow a pin extractor tool. Insert the extractor around the
female pin, to the bottom of the connector. move the tool to a slight angle and make a circular motion. This will close the splayed pins. NOTE: Just close it up, don't kill it.

If this doesn't work, there might be a defective crimp on the connection, with a broken wire. In which case, replace the "Y", or P/S pins, as applicable. I don't think there are any really good "y"s available, but you could make your own, albiet, you'll still be using tin pins, but better wire and crimping.

b-