ATARAID and KERNEL-2.6.9
Dear Sirs,
I have a little problem or maybe big one. I try to
put to work the kernel-2.6.9 on my machine. I have a slackware current install and the following hardware.
AMD Athlon
512MB RAM
HPT 370 RAID controller
and 2 HDD in RAID1
So when I start the kernel-ataraid-2.4.27 everything works OK. When I start the installed kernel-2.6.9 I get the following error message:
VFS: Cannot openroot device "7203" or unknown-block(114,3) Please append a correct "root=" option
Kernel panic: VFS: Unable to mount root fs on unknown-block(114,3)
On my lilo.conf is root=/dev/ataraid/d0p3
as this is the / partition.
I tried to put the root=/dev/hde at the lilo prompt but no success.
I tried many many forums but nobody was able to answer me. So my last sollution is you and I will very very apreciate it if you can give me some hints how to do it. I append you also a dmesg from the 2.4.27 kernel.
Many thanks in advance for your help !!!
Best Regards
Sasa Ostrouska
Quoted 5 lines · Sasa Ostrouska
Dear Sirs,
I have a little problem or maybe big one. I try to
put to work the kernel-2.6.9 on my machine. I have a slackware current install and the following hardware.
use dmraid for 2.6.x.
Jeff
Quoted 13 lines · Jeff Garzik
Quoted 5 lines · Sasa Ostrouska
Dear Sirs,
I have a little problem or maybe big one. I try to
put to work the kernel-2.6.9 on my machine. I have a slackware current install and the following hardware.use dmraid for 2.6.x.
Jeff
Dear Jeff,
Many thanks for your reply. I would like to ask you if
you have some experience with this ? This means if you can point me to a good how to or some documentation on the net, or maybe describe how to do the steps. This just because I tried to instal the lilo but it gave me an error when I did /sbin/lilo and the root option was set to /dev/ataraid/d0. I tried once to
boot the machine with the options like noinitrd root=/dev/hde and it booted up but then complained that the partitiona are mounted rw and to give the root password for correcting the errors. After that I rebooted to give the ro option and it never had booted again.
Many many thanks for your help.
Best Regards
Sasa Ostrouska