PCMCIA Networking w/u-boot-1.1.1+
Hello Everyone:
We have become quite interested in using u-boot's tftp & dhcp features. Unfortunately, our custom board has only a PCMCIA slot (no ethernet interface). So if we are to use networking at all, we'll have to do it with PCMCIA cards.
What is the status of PCMCIA networking in u-boot? I have looked through the sources and it seems that current PCMCIA functionality is limited to ATA flash cards at the moment. If this is so, what would we have to do to get PCMCIA networking running in u-boot?
I am not put off by working on PCMCIA drivers - I have already done a lot of PCMCIA net driver work this month, so a little bit more isn't going to kill me. We need to get NE2000 working first, and then Cisco/Aironet wireless working after that. If at all possible, please say a few words about what would have to be done where in u-boot to make this happen. I am first and foremost interested in doing this job correctly so that I can submit patches to Wolfgang et al.
Thanks in advance,
craig vanderborgh
voxware incorporated
A message that is not in the archive (sent off-list or not yet received): [email protected]
-----BEGIN PGP SIGNED MESSAGE-----
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
"Craig" == Craig A Vanderborgh <[email protected]> writes:
Craig> I am not put off by working on PCMCIA drivers - I have already done a lot of Craig> PCMCIA net driver work this month, so a little bit more isn't going to kill Craig> me. We need to get NE2000 working first, and then Cisco/Aironet wireless Craig> working after that. If at all possible, please say a few
If you use a 16-bit PCMCIA, or keep a 32-bit card in 16-bit mode, then
you can probably use a good ole polled-mode ne2000.c.
- --
] Michael Richardson Xelerance Corporation, Ottawa, ON | firewalls [ ] mcr @ xelerance.com Now doing IPsec training, see |net architect[ ] http://www.sandelman.ca/mcr/ www.xelerance.com/training/ |device driver[
] panic("Just another Debian GNU/Linux using, kernel hacking, security guy"); [ -----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (GNU/Linux)
Comment: Finger me for keys
iQCVAwUBQeXKl4qHRg3pndX9AQGK8QP+Irv8nWeed98nVlfzkHppuF3rPiBgcMPF f6bQzE2hUcLFClNZDTfA1wJwpFM7IO9PBFIu1HqKXSuQP741W2eKaIV+2F3A8uiG NiigKS61+hmQyUh3TSA/yRu0KBYf+vENA6Zzl5F/w7D4h/bFZCsQbboln6dDZRCN cqKzz/oFdu0=
=+h01
-----END PGP SIGNATURE-----
Quoted 2 lines · In message <[email protected]> you wrote:
What is the status of PCMCIA networking in u-boot? I have looked
Non-existent.
Quoted 1 line
have to do to get PCMCIA networking running in u-boot?
Implement it from scratch.
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de How come everyone's going so slow if it's called rush hour?