U-boot stable asks for SYS_LOAD_ADDR when compiling for Le Potato
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hi Kenneth,
Quoted 4 lines · Kenneth Roland
As the subject says, I am unable to successfully compile buildroot for this board. I used this repo (https://github.com/mathieu-lm/libretech-cc-buildroot), as support for the Le Potato dev board isn't in mainstream. This fork isn't too old as it is dated 2020.02 in menu makeconfig?. I assume that because this repo is slightly dated that it doesn't account for newer changes for u-boot? Uname and logs are attached. I used the value
0x1000000as given in the device's forums (https://forum.loverpi.com/discussion/748/u-boot-guide-for-le-potato-aml-s905x-cc).
u-boot Guide for Le Potato AML-S905X-CC<https://forum.loverpi.com/discussion/748/u-boot-guide-for-le-potato-aml-s905x-cc>
The boot priority of Le Potato is as follows: eMMC then SD. The current version of u-boot found in the images is the 2019.04 release.
forum.loverpi.com
Toolchain and u-boot versions are static, the fault probably lies within the instructions in the README of [1].
Clean up your build and initialize it properly:
$ make clean $ make meson-gxl-s905x-libretech-cc_defconfig
Then run 'make'.
<cut>
Kind regards,
Andreas
[1] https://github.com/mathieu-lm/libretech-cc-buildroot
_______________________________________________
buildroot mailing list
[email protected]
https://lists.buildroot.org/mailman/listinfo/buildroot