Skip to contentSkip to conversation

omap1510 Innovator works! - Thanks!

U-Boot-Users Tim Bird 1 participant 1 message Feb 4, 2005

lore
Share & tools
lore

Tim Bird

author
#0 lore raw

I just wanted to say thanks for the great software. I had been using rrload on my omap1510 innovator board. Yesterday, I got u-boot 1.1.2 compiled, loading, running, and flashed on the board - and I'm very happy! It's nice to have a more full-featured bootloader for my development work. Networking worked, as did all serial, memory and flash operations that I tested.

I had to change one CFLAG in cpu/arm925t/config.mk:
I changed -mshort-load-bytes to -malignment-traps, to support my gcc 3.4.3 compiler.

A patch similar to this was submitted previously and rejected, because it breaks older compilers. I'm only including it here for others who may care. (This is not a request for integration.)

-----------

config.mk +1 -1
diff -u -u -r1.1 -r1.2
@@ -22,6 +22,6 @@
 #
 
 PLATFORM_RELFLAGS += -fno-strict-aliasing  -fno-common -ffixed-r8 \
-	-mshort-load-bytes -msoft-float
+	-malignment-traps -msoft-float
 
 PLATFORM_CPPFLAGS += -mapcs-32 -march=armv4

-------------

I notice that there's no doc/README.omap1510inn. I'd be willing to write one if no one else is already working on one (although I'm not an expert by any means.)

Thanks again for u-boot!
-- Tim

=============================
Tim Bird
Architecture Group Chair, CE Linux Forum
Senior Staff Engineer, Sony Electronics
=============================