Skip to contentSkip to conversation

Patch for 8xx watchdog handler for >=2.6.10

PATCH Carsten Juttner 1 participant 1 message Feb 11, 2005

lore
Share & tools
lore
#0 lore raw

Hi,

our mpc 823 based embedded board (STB, dbox2) would hang with every kernel starting from 2.6.10-rc1_linuxppc. I tracked the problem down to the watchdog interrupt handler setup and the new generic interrupt handling routines (which caused an uninitialized pointer because kmalloc was used before the kmem_cache was initialized).

As said, this was only an issue if CONFIG_8xx_WDT was set.

I have attached a simple patch for the handler.

Regards,
Carsten Juttner

arch/ppc/syslib/m8xx_wdt.c +11 -2
diff -Nru a/arch/ppc/syslib/m8xx_wdt.c b/arch/ppc/syslib/m8xx_wdt.c
@@ -11,6 +11,7 @@
 
 #include <linux/init.h>
 #include <linux/interrupt.h>
+#include <linux/irq.h>
 #include <linux/kernel.h>
 #include <linux/sched.h>
 #include <asm/8xx_immap.h>
@@ -18,6 +19,14 @@
 
 static int wdt_timeout;
 
+static irqreturn_t m8xx_wdt_interrupt(int, void *, struct pt_regs *);
+static struct irqaction m8xx_wdt_irqaction = {
+    .handler = m8xx_wdt_interrupt,
+    .flags = 0,
+    .name = "watchdog",
+    .dev_id = NULL
+};
+
 void m8xx_wdt_reset(void)
 {
 	volatile immap_t *imap = (volatile immap_t *)IMAP_ADDR;
@@ -84,8 +93,8 @@
 	imap->im_sit.sit_piscr =
 	    (mk_int_int_mask(PIT_INTERRUPT) << 8) | PISCR_PIE | PISCR_PTE;
 
-	if (request_irq(PIT_INTERRUPT, m8xx_wdt_interrupt, 0, "watchdog", NULL))
-		panic("m8xx_wdt: could not allocate watchdog irq!");
+	if (setup_irq(PIT_INTERRUPT, &m8xx_wdt_irqaction))
+		panic("m8xx_wdt: error setting up the watchdog irq!");
 
 	printk(KERN_NOTICE
 	       "m8xx_wdt: keep-alive trigger installed (PITC: 0x%04X)\n", pitc);