status reports updated
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 5 lines · Bodo Eggert
Quoted 1 line · Tomasz Chmielewski
Is there a way to check what firmware a drive has
The obvious one: hdparm
<Ingrid>
Or, since hdparm doesn't work for SCSI devices,
cat /sys/block/sd$n/device/rev
(might depend on the vendor)
Signature · 4 lines
Funny quotes: 21. Support bacteria - they're the only culture some people have. Friß, Spammer: [email protected] [email protected]
Quoted 7 lines · Bodo Eggert
Quoted 5 lines · Bodo Eggert
Quoted 1 line · Tomasz Chmielewski
Is there a way to check what firmware a drive has
Quoted 8 lines
Quoted 1 line
The obvious one: hdparm
<Ingrid>
Or, since hdparm doesn't work for SCSI devices,
cat/sys/block/sd$n/device/rev(might depend on the vendor)
Oh, indeed!
# cat /sys/block/sda/device/rev 3.01
So what about SATA blacklisting based on a model/firmware version rather than on a model only?
My model (ST3200822AS) is blacklisted, though I'm stress-testing it for the second day and nothing happened, so I assume I may not be affected.
The question is, if I'm not affected because:
1) I'm lucky and it didn't happen yet,
2) hard drive (ST3200822AS) firmware is better - is anyone in contact with Seagate?
3) SATA controller (Silicon Image SiI 3112) BIOS is better - is anyone in contact with Silicon Image?
Additional question: is there a way to check the SATA controller BIOS as easily as it is with the drive firmware?
Tomek
----------------------------------------------------------------------
Startuj z INTERIA.PL! >>> http://link.interia.pl/f186c