Skip to contentSkip to conversation

NAT/MASQ on eth0 - doubt

DISCUSSION [email protected] 2 participants 2 messages May 1, 2005

lore
Share & tools
lore
#0 lore raw

Hello,
My server is on Mandriva 10.1
eth0 is WAN with static IP connected to 512K DSL eth1 is LAN - 192.168.0.0/24 and 192.168.21.0/24

I have used webmin and done :

Do network address translation on external interface:eth0

This gives the following entries in iptables :

# Generated by iptables-save v1.2.9 on Tue Apr 26 14:50:01 2005 *nat
:OUTPUT ACCEPT [0:0]
:PREROUTING ACCEPT [0:0]
:POSTROUTING ACCEPT [0:0]
-A POSTROUTING -o eth0 -j MASQUERADE

So should I just masq all out ?

Is it possible to use my static IP or subnets details to rewrite the above masq rule while I am doing a NAT on eth0 ?

If yes how ?

Thanks

Varun

#1 lore raw
Quoted 3 lines

My server is on Mandriva 10.1
eth0 is WAN with static IP connected to 512K DSL
eth1 is LAN - 192.168.0.0/24 and 192.168.21.0/24

....

Quoted 11 lines

# Generated by iptables-save v1.2.9 on Tue Apr 26 14:50:01 2005 *nat
:OUTPUT ACCEPT [0:0]
:PREROUTING ACCEPT [0:0]
:POSTROUTING ACCEPT [0:0]
-A POSTROUTING -o eth0 -j MASQUERADE

So should I just masq all out ?

Is it possible to use my static IP or subnets details to rewrite the above masq rule while I am doing a NAT on eth0 ?

Normally, per "man iptables" documentation, you MASQUERADE traffic that is on some sort of dynamic IP connection and SNAT traffic that is on a static IP connection. The main difference is that MASQUERADE will clear the state of MASQUERADing / SNATing when the interface goes down where as SNAT will not do so. The idea behind this is that you will likely get a different IP when you reconnect with a dynamic connection and thus the state information is stale and invalid. Seeing as how you have a static IP on your INet connection I would change the MASQUERADE target to be SNAT.

Grant. . . .