IP30 hang on warm boot
Gentoo has been running flawlessly on this IP30 for the last month I've had it, except for one thing. I've noticed that when I reboot, it hangs at the below denoted spot:
<dmesg>
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
loop: loaded (max 8 devices)
Quoted 1 line
Quoted 1 line
Quoted 1 line
HANGS HERE
IOC3 SuperIO: registered IOC3 at 900000001f600000, IRQ 12 (chip 0). ttyS0 at IOC3 0x1f620178 (irq = 64) is a 16550A
ttyS1 at IOC3 0x1f620170 (irq = 65) is a 16550A
Found DS2502 NIC registration number 21:e5:b0:02:00:00, CRC 9b. Ethernet address is 08:00:69:13:6f:e1.
eth0: link up, 100Mbps, full-duplex, lpa 0x01E1
eth0: Using PHY 1, vendor 0x15f42, model 2, rev 3.
eth0: IOC3 SSRAM has 128 kbyte.
qla1280: QLA1040 found on PCI bus 0, dev 0
PCI: Enabling device 0000:00:00.0 (0006 -> 0007) </dmesg>
This happens every single warm boot, and never on a cold boot. This box is
running gentoo's mips-sources-2.6.12 kernel (l-m.org cvs 20050703). I've posted the actual config[1] if it helps.
[1] http://dev.gentoo.org/~ka0ttic/mips/ip30/ip30-config
Thanks
Signature · 5 lines
Science and religion are in full accord but science and faith are in complete discord. Aaron Walker <[email protected]> [ BSD | commonbox | cron | cvs-utils | mips | netmon | shell-tools | vim ]
Hello,
Try the current (R25) Octane patches at
http://www.linux-mips.org/~skylark/.
The IOC3 support code has been in for a massive overhaul since the gentoo sources have been done by `K. Also, the PCI code is completely new. And ALSA supports many more features of the RAD1.
I hope you will be pleasantly surprised,
Stanislaw Skowronek
--<=>--
"I wish for that night-time
To last for a lifetime.
The darkness around me
Shores of a solar sea."
Quoted 3 lines · Stanislaw Skowronek
The IOC3 support code has been in for a massive overhaul since the gentoo sources have been done by `K. Also, the PCI code is completely new. And ALSA supports many more features of the RAD1.
Sweet. Thanks.
Signature · 4 lines
I smell a wumpus. Aaron Walker <[email protected]> [ BSD | commonbox | cron | cvs-utils | mips | netmon | shell-tools | vim ]