8xx board-specific platform setup for fs_enet

@@ -527,6 +527,42 @@ config WINCEPT
 
 endchoice
 
+menu "Freescale Ethernet driver platform-specific options"
+	depends on FS_ENET
+	
+	config MPC8xx_SECOND_ETH
+	bool "Second Ethernet channel"
+	depends on (MPC885ADS || MPC86xADS)
+	default y
+	help
+	  This enables support for second Ethernet on MPC885ADS and MPC86xADS boards.
+	  The latter will use SCC1, for 885ADS you can select it below.
+	
+	choice 
+		prompt "Second Ethernet channel"
+		depends on MPC8xx_SECOND_ETH
+		default MPC885ADS_SECOND_ETH_FEC2
+				
+		config MPC885ADS_SECOND_ETH_FEC2
+		bool "FEC2"
+		help
+		  Enable FEC2 to serve as 2-nd Ethernet channel. Note that SMC2 
+		  (often 2-nd UART) will not work if this is enabled.
+	  
+		config MPC885ADS_SECOND_ETH_SCC
+		bool "SCC3"
+    		help
+		  Enable SCC3 to serve as 2-nd Ethernet channel. Note that SMC2 
+		  (often 1-nd UART) will not work if this is enabled.
+	
+	endchoice
+	
+		config MPC885ADS_SCC_ENET_FIXED
+		depends on MPC885ADS_SECOND_ETH_SCC
+		default n
+		bool "Use fixed MII-less mode for SCC Ethernet"
+endmenu
+
 choice
 	prompt "Machine Type"
 	depends on 6xx || POWER3 || POWER4

@@ -46,6 +46,7 @@ obj-$(CONFIG_SANDPOINT)		+= sandpoint.o
 obj-$(CONFIG_SBC82xx)		+= sbc82xx.o
 obj-$(CONFIG_SPRUCE)		+= spruce.o
 obj-$(CONFIG_LITE5200)		+= lite5200.o
+obj-$(CONFIG_MPC885ADS)	+= mpc885ads_setup.o
 
 ifeq ($(CONFIG_SMP),y)
 obj-$(CONFIG_PPC_PMAC)		+= pmac_smp.o