Skip to contentSkip to conversation

Problem with MMC card reader

DISCUSSION ScytheBlade1 3 participants 3 messages Aug 23, 2005 – Aug 28, 2005

lore
Share & tools
lore
#0 lore raw

I recently purchased:

http://www.mitsumi.com/products/FA404.htm

I've enabled everything needed...the CF port works flawlessly. However, the SD slot does *not*. I've got about 5+ pages worth of dmesg output related to this (MMC is NOT debug enabled, and I still get a disturbing amount of output). Would here be the best place to post this, or would a different list be better? (Recommendations as to which list are welcomed :)).

#1 lore raw
Quoted 6 lines · On Mon, Aug 22, 2005 at 11:16:46PM -0600, ScytheBlade1 wrote:

I've enabled everything needed...the CF port works flawlessly. However, the SD slot does *not*. I've got about 5+ pages worth of dmesg output related to this (MMC is NOT debug enabled, and I still get a disturbing amount of output). Would here be the best place to post this, or would a different list be better? (Recommendations as to which list are welcomed :)).

CONFIG_SCSI_MULTI_LUN=y

This is probably the answer you needed... because, the reader is a single device, with multiple slots, and usb_storage driver uses SCSI infrastructure, so multiple slots map to multiple SCSI LUN's.

Atleast, it worked for all my readers during the years :))

Signature · 4 lines
           [email protected], IRC:*@Martin, /bin/zsh. C|N>K
Linux moria 2.6.11 #1 Wed Mar 9 19:08:59 CET 2005 i686
 11:23:27 up 27 days,  3:56,  4 users,  load average: 0.11, 0.23, 0.29
We are Microsoft. First we'll reboot, and then asimilate you.

This message has been 'sanitized'. This means that potentially dangerous content has been rewritten or removed. The following log describes which actions were taken.

Sanitizer (start="1124789169"):
Forcing message to be multipart/mixed, to facilitate logging.

Anomy 0.0.0 : Sanitizer.pm
$Id: Sanitizer.pm,v 1.87 2004/05/07 17:42:12 bre Exp $

#2 lore raw
In reply to ScytheBlade1
Quoted 5 lines · On Mon, Aug 22, 2005 at 11:16:46PM -0600, ScytheBlade1 wrote:

I've enabled everything needed...the CF port works flawlessly. However, the SD slot does *not*. I've got about 5+ pages worth of dmesg output related to this (MMC is NOT debug enabled, and I still get a disturbing amount of output). Would here be the best place to post this, or would a different list be better?

Since it seems to be a USB device, the USB mailing list could be an appropriate place.

Signature · 3 lines
Russell King
 Linux kernel    2.6 ARM Linux   - http://www.arm.linux.org.uk/
 maintainer of:  2.6 Serial core