Skip to contentSkip to conversation

TAP and piix4-udma resyncs against 0.7.2 release

PATCH In review Mad Monkey 2 participants 3 messages Sep 11, 2005 – Sep 12, 2005

lore
Share & tools
lore

Mad Monkey

author
#0 lore raw

PATCH 1/1 TAP and piix4-udma resyncs against 0.7.2 release

Hi,

1/ Total newbie on QEmu-devel so please inform me if I'm doing anything NOT the way I should... Thx.
2/ Attached are the resyncs against 0.7.2 release for :
- the TAP device support (http://www.h6.dion.ne.jp/~kazuw/qemu-win/qemu-0.7.1-tap.zip)
- the PIIX4 BusMaster ATA (UltraDMA/33) support (http://ebisa.hp.infoseek.co.jp/qemu/arcs/qemu-piix4-udma-20050514.zip)
3/ As for the hard disk benchmark, SiSoft Sandra reports a 500% gain ! Althgough I'm not sure the speed increase is THAT significant, it feels pretty fast indeed... 4/ Greetings, bravos and thank yous to the original authors of the patches

Feedback is welcome.

-- Mad Monkey

author
#1 lore raw

Ooopps... Little mistake here...

SiSoft Sandra reports ONLY a 400% gain.(5 times faster is indeed a 400% gain !)

A few details about my config :
- Host and VMs are XP SP2.
- IDE controller for the unpatched VM reports "Mode PIO"
- IDE controller for the patched VM reports "Ultra DMA Mode 2"
- Host has a RAID-0 dual ultra ata 160gb hd (nForce 4 controller)
- VMs have 4gb QCow hd file

Hope it helps...

-- Mad Monkey

Quoted 23 lines · Mad Monkey

Hi,

1/ Total newbie on QEmu-devel so please inform me if I'm doing anything NOT the way I should... Thx.
2/ Attached are the resyncs against 0.7.2 release for :
- the TAP device support
(http://www.h6.dion.ne.jp/~kazuw/qemu-win/qemu-0.7.1-tap.zip)
- the PIIX4 BusMaster ATA (UltraDMA/33) support
(http://ebisa.hp.infoseek.co.jp/qemu/arcs/qemu-piix4-udma-20050514.zip)
3/ As for the hard disk benchmark, SiSoft Sandra reports a 500% gain ! Althgough I'm not sure the speed increase is THAT significant, it feels pretty fast indeed... 4/ Greetings, bravos and thank yous to the original authors of the patches

Feedback is welcome.

-- Mad Monkey

------------------------------------------------------------------------

_______________________________________________
Qemu-devel mailing list
[email protected]
http://lists.nongnu.org/mailman/listinfo/qemu-devel

#2 lore raw

Re: [Qemu-devel] [patch] TAP and piix4-udma resyncs against 0.7.2release

In reply to Mad Monkey
Quoted 5 lines · Mad Monkey

2/ Attached are the resyncs against 0.7.2 release for :
- the TAP device support
(http://www.h6.dion.ne.jp/~kazuw/qemu-win/qemu-0.7.1-tap.zip)
- the PIIX4 BusMaster ATA (UltraDMA/33) support
(http://ebisa.hp.infoseek.co.jp/qemu/arcs/qemu-piix4-udma-20050514.zip)

I will update them. But the DMA patch has a problem.

Quoted 7 lines · Brad Campbell

Interesting.. after applying that patch both my win2k and winxp installs refused to boot.
Winxp gets as far as the safe mode selection screen, select safe mode and it goes straight back to the selection screen. Win2k just bluescreens during the boot process mumbling something about being unable to access the boot disk.

For WinXP, it was the same state I have experienced when I installed WinXP without a patch. I don't think it is related to the patch.

For Win2k, I also see the same blue screen. It says that INACCESSIBLE_BOOT_DEVICE. I couldn't find why.

Regards,
Kazu