Skip to contentSkip to conversation

2.6.14-rc1-mm1 unable to mount root on HP Smart6i cciss was: Re: 2.6.14-rc1-mm1

DISCUSSION Stefan Schmidt 1 participant 1 message Sep 20, 2005 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 1 line · Andrew Morton

Changes since 2.6.13-mm3:

...

Review

Quoted 8 lines
(quoted diff) +0 -8
-cciss-new-controller-pci-subsystem-ids.patch
-cciss-busy_initializing-flag.patch
-cciss-new-disk-register-deregister-routines.patch
-cciss-direct-lookup-for-command-completions.patch
-cciss-bug-fix-in-cciss_remove_one.patch
-cciss-fix-for-dma-brokeness.patch
-cciss-one-button-disaster-recovery-support.patch
-cciss-scsi-tape-info-for-proc.patch

On a HP Proliant DL385 with Smart6i Controller 2.6.14-rc1-mm1 was unable to mount root although the device file existed and had the correct major/minor numbers. 2.6.13-vanilla was able to find and mount the very same root-device using the same config. Root-device was the first partition the first SCSI disk exported as JBOD which in smart-controller terms means it is a raid0. /dev/cciss/c0d0p1
I was able to see the devices flying by during the booting of 2.6.14-rc1-mm1 so the controller, its disks and partitions were recognized correctly, it was just unable to map the major/minor number to a device or partition.

best regards,

Stefan Schmidt