bonding: fix typos in bonding documentation
Subsystems (3)
PATCH 1/1 bonding: fix typos in bonding documentation
Fix some simple typos in the bonding.txt file. The typos are in areas relating to loading the bonding driver multiple times.
Signed-off-by John W. Linville <[email protected]>
---
Documentation/networking/bonding.txt | 5 +++-- 1 files changed, 3 insertions(+), 2 deletions(-)
Documentation/networking/bonding.txt +3 -2
@@ -777,7 +777,7 @@ doing so is the same as described in the Manually" section, below. NOTE: It has been observed that some Red Hat supplied kernels -are apparently unable to rename modules at load time (the "-obonding1" +are apparently unable to rename modules at load time (the "-o bond1" part). Attempts to pass that option to modprobe will produce an "Operation not permitted" error. This has been reported on some Fedora Core kernels, and has been seen on RHEL 4 as well. On kernels
@@ -883,7 +883,8 @@ the above does not work, and the second its options. In that case, the second options line can be substituted as follows: -install bonding1 /sbin/modprobe bonding -obond1 mode=balance-alb miimon=50 +install bond1 /sbin/modprobe --ignore-install bonding -o bond1 \ + mode=balance-alb miimon=50 This may be repeated any number of times, specifying a new and unique name in place of bond1 for each subsequent instance.
Jeff Garzik
Appliedapplied