virtual NICs
Curious question:
If I configure multiple IP addresses to a NIC, and assign 1.2.3.4 to
eth0 and 5.6.7.8 to eth0:0 (a virtual NIC) is there extra work involved on the part of the CPU or memory or whatever in routing traffic via 5.6.7.8 than 1.2.3.4.. I mean does one IP have an advantage over the other in any sense?
Thanks,
Davy
Quoted 8 lines · Davy Durham
Curious question:
If I configure multiple IP addresses to a NIC, and assign 1.2.3.4 to
eth0 and 5.6.7.8 to eth0:0 (a virtual NIC) is there extra work involved on the part of the CPU or memory or whatever in routing traffic via 5.6.7.8 than 1.2.3.4.. I mean does one IP have an advantage over the other in any sense?
Of course there is extra work! Any time something has to be checked (filtered), there is the overhead of the filtering. In the case of two or more IP addresses, the software has to perform an ARP on two or more IPs. This means that it needs to "listen" for more queries. Note that machines on Ethernet, communicate using their hardware- addresses i.e., the "IEEE station address". But, the initial route to the target machine needs to be set up by broadcasting an IP address, thereby asking everybody on the LAN if the IP address belongs to them. Hopefully only one machine answers. This sequence is called ARP (address resolution protocol).
Adding more IP addresses is like adding more machines as far as the source (perhaps a router) is concerned. Adding more IP addresses to a single host is sometimes necessary, but it is not without cost. Basically, don't do it unless it's necessary.
Quoted 3 lines
Thanks,
Davy
-
Cheers,
Dick Johnson
Penguin : Linux version 2.6.13.4 on an i686 machine (5589.44 BogoMips). Warning : 98.36% of all statistics are fiction.
.
****************************************************************
The information transmitted in this message is confidential and may be privileged. Any review, retransmission, dissemination, or other use of this information by persons or entities other than the intended recipient is prohibited. If you are not the intended recipient, please notify Analogic Corporation immediately - by replying to this message or by sending an email to [email protected] - and destroy all copies of this information, including any attachments, without reading or disclosing them.
Thank you.
First, thanks for the prompt response.
Quoted 13 lines · linux-os (Dick Johnson)
Of course there is extra work! Any time something has to be checked (filtered), there is the overhead of the filtering. In the case of two or more IP addresses, the software has to perform an ARP on two or more IPs. This means that it needs to "listen" for more queries. Note that machines on Ethernet, communicate using their hardware- addresses i.e., the "IEEE station address". But, the initial route to the target machine needs to be set up by broadcasting an IP address, thereby asking everybody on the LAN if the IP address belongs to them. Hopefully only one machine answers. This sequence is called ARP (address resolution protocol).
My question was whether the one being defined to eth0 has an advantage over the one assigned to eth0:0 since one is real and one is virtual. My uninformed instinct told me to wonder if the NIC hardware itself somehow gets told to handle the IP assigned to eth0 and something in the linux software has to handle the IP assigned to eth0:0
I realize that the machine will have to do more work total. But I wonder if it's any more work than if the server has two NICs with two different IPs.
Quoted 7 lines
Adding more IP addresses is like adding more machines as far as the source (perhaps a router) is concerned. Adding more IP addresses to a single host is sometimes necessary, but it is not without cost. Basically, don't do it unless it's necessary.
It's necessary because of the in-born inability for name based virtual hosting to be done over SSL (though I think this inability was unnecessary in that it could have been relaxed if just a little bit of unsecured data could be transmitted in the SSL header allowing the server to make some decision based on that clear data.. but that's another matter).
Thanks again,
Davy
Hi,
Just a quick note..
iirc, virtual interfaces are necessary in order to configure multiple IP addresses using "ifconfig", but if you use iproute2's tools you can add any/all IPs to one interface (the original, eg eth0, br0, vlan0001 etc) with a command like "ip addr add 12.3.45.66/28 dev eth0" and then all the addresses are considered equal; although ifconfig will only list one of the IPs (it appears that it is restricted to "understanding" only one IP per interface)
Cheers,
Lee Causier.
Undergraduate
BSc Computer Science (Year 1)
Quoted 49 lines · Davy Durham
First, thanks for the prompt response.
Quoted 13 lines · linux-os (Dick Johnson)
Of course there is extra work! Any time something has to be checked (filtered), there is the overhead of the filtering. In the case of two or more IP addresses, the software has to perform an ARP on two or more IPs. This means that it needs to "listen" for more queries. Note that machines on Ethernet, communicate using their hardware- addresses i.e., the "IEEE station address". But, the initial route to the target machine needs to be set up by broadcasting an IP address, thereby asking everybody on the LAN if the IP address belongs to them. Hopefully only one machine answers. This sequence is called ARP (address resolution protocol).
My question was whether the one being defined to eth0 has an advantage over the one assigned to eth0:0 since one is real and one is virtual. My uninformed instinct told me to wonder if the NIC hardware itself somehow gets told to handle the IP assigned to eth0 and something in the linux software has to handle the IP assigned to eth0:0
I realize that the machine will have to do more work total. But I wonder if it's any more work than if the server has two NICs with two different IPs.
Quoted 7 lines
Adding more IP addresses is like adding more machines as far as the source (perhaps a router) is concerned. Adding more IP addresses to a single host is sometimes necessary, but it is not without cost. Basically, don't do it unless it's necessary.
It's necessary because of the in-born inability for name based virtual hosting to be done over SSL (though I think this inability was unnecessary in that it could have been relaxed if just a little bit of unsecured data could be transmitted in the SSL header allowing the server to make some decision based on that clear data.. but that's another matter).
Thanks again,
Davy
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Quoted 2 lines · In article <[email protected]> you…
iirc, virtual interfaces are necessary in order to configure multiple IP addresses using "ifconfig"
"ifconfig add" works only with v6, yes. (However this feature is easy to add
http://net-tools.berlios.de)
Note: there are some differences between alias interfaces and additional interface addresses, because there is a primary address.
Gruss
Bernd