Skip to contentSkip to conversation

aic79xx should be able to ignore HostRAID enabled adapters

PATCH Robert Hancock 1 participant 1 message Dec 2, 2005 3 messages not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

#3 lore raw
Quoted 7 lines · Darrick J. Wong

Jeff,

Good, this was the exact response that I was hoping for, as I've been told to convince Adaptec to drop the binary RAID drivers in favor of helping out dmraid development instead. That process will probably be difficult, but at least I now have incontrovertible proof that nobody will bend over backwards to support them and that dmraid is the way to go. Not that I'm terribly surprised by this.

It's good that there is a push to get non-binary-module support for these controllers in Linux. It's a shame that this is only happening now though.

It does rather suck that IBM changed to use this AIC79xx controller with "HostRAID" in the x346, x236, etc. servers. The last generation of servers (x235, x345) used an LSI Logic MPT Fusion controller which could do RAID 1 in hardware (or at least firmware) without a special driver - this sufficed for certain applications. With the new machines, RAID on the onboard controller requires using the stupid binary module which is only built against certain specific kernels, or using pure software RAID..

Signature · 3 lines
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from [email protected]
Home Page: http://www.roberthancock.com/